Vector JL E-DOCK 2018+ MID WIDTH Installation Instructions
  1. Manuals
  2. Brands
  3. Vector Manuals
  4. Automobile Accessories
  5. Installation instructions
Vector JL E-DOCK 2018+ MID WIDTH Installation Instructions

Vector JL E-DOCK 2018+ MID WIDTH Installation Instructions

Hide thumbs
1
2
3

Quick Links

JL E-DOCK 2018+ MID WIDTH INSTALLATION INSTRUCTIONS
PARTS LIST
Corner connectors
Stainless Steel End Caps (Installed)
Aluminum Track Pieces
Left and Right Brackets
1/4" Set Screws
1/4" Button Head Screws
REQUIRED TOOLS
Phillips Screw Driver
1/8" and 5/32" Hex L-Key (allen key)
PLEASE READ BEFORE BEGINNING INSTALLATION
Prior to starting the installation of this product, we suggest reading the entire instruction manual.
Several of the steps involved in installation of this product are fairly complex, and reading through
ahead of time will help you with a pain free installation. An extra minute or two spent now will save a
lot of headache down the road.
This product must be installed by someone with a certain amount of mechanical aptitude. Vector
OffRoad can not be held liable for damage caused to your vehicle due to poor or incomplete installa-
tion of this product. If you have any questions, are missing parts, or need help locating a skilled instal-
lation shop in your area, please contact us.
As with all of our products the JL E-Dock is designed for off-road use only, compatibility with OEM
systems has not been formally tested.
QTY
2
2
3
2
4
2
Page 1 of 3
REV 091018
OFFROAD.COM
loading

Summary of Contents for Vector JL E-DOCK 2018+ MID WIDTH

  • Page 1 An extra minute or two spent now will save a lot of headache down the road. This product must be installed by someone with a certain amount of mechanical aptitude. Vector OffRoad can not be held liable for damage caused to your vehicle due to poor or incomplete installa- tion of this product.
  • Page 2 JL E-DOCK MID WIDTH 2018+ INSTALLATION INSTRUCTIONS OFFROAD.COM PREPARE THE DASH FOR INSTALLATION 1. Reach inside the dash top cubby and remove the factory rubber liner. You may reuse the rubber liner by cutting off the two outside wings or simply leave it out of the vehicle.
  • Page 3 5. Replace the rubber tray if you trimmed it to t and tighten the set screws in the corner connectors. 6. Congratulations, installation is complete. COMMENTS OR QUESTIONS PLEASE CONTACT: VECTOR OFF ROAD EMAIL: [email protected] WEBSITE: http://www.vectoroffroad.com Page 3 of 3 REV 091018...