Turbidity Sensor - Calibration - GE GDWT668V Service Manual

Hide thumbs Also See for GDWT668V:

Table of Contents

Turbidity Sensor - Calibration

When a main control board is replaced, it

will automatically start a "factory test

mode" During that cycle, the turbidity

sensor will be calibrated.

If a turbidity sensor is replaced w/o

replacing a control, the turbidity sensor

can be calibrated by doing the following:

1. Open the door and press the

Start/Reset pad 100 times.

2. That will flag the board to calibrate the

sensor during the next full dishwasher

cycle.

Failure of the turbidity sensor will result in maximum wash/rinse cycles.

28 /

GE Title or job number /

8/2/2011

Table of Contents