Table of Contents
24
www.electrolux.com
At the end of the load detection, in case
of drum overload, the indicator
flashing in the display:
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start Pause
the programme again. The SensiCare
phase can be repeated up to three times
(see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again depending
on the capacity of water
absorption of the fabrics.
The SensiCare detection is
carried out with complete
washing programmes only
and if the programme
duration has not been
reduced by means of the
Time Manager button.
10.9 Interrupting a programme
and changing the options
When the programme is running, you
can change only some options:
1. Touch the Start Pause
The related indicator flashes.
2. Change the options. The given
information in the display changes
accordingly.
3. Touch the button Start Pause
again.
The washing programme continues.
10.10 Cancelling a running
programme
1. Press the button On/Off to cancel the
programme and to deactivate the
appliance.
2. Press the button On/Off again to
is
button to start
There is also an alternative way of
cancelling:
1. Rotate the selector knob to the "Reset"
position
2. Wait for 1 second. The display shows
Now, you can set a new washing
programme.
10.11 Opening the door -
Adding garments
While a programme or the delay start
operates, the appliance door is locked.
The display shows the indicator
button.
1. Touch the Start Pause
In the display the related door lock
indicator goes off.
2. Open the appliance door. If
The programme or the delay start
continues.
10.12 End of the programme
When the programme has finished, the
appliance stops automatically. The
activate the appliance.
If the SensiCare System has
completed and the water
filling has already started,
the new programme starts
without repeating the
SensiCare System. The
water and the detergent are
not drained out in order to
avoid waste. The display
shows the maximum
duration of the programme,
updating it about 20 minutes
after the starting of the new
programme.
.
.
If the temperature and level
of the water in the drum are
too high and/or the drum is
still rotating you should not
open the door.
necessary, add or remove the items.
Close the door and touch the Start
Pause
button.
.
button.
- Quick Links:
- Control Panel
Hide quick links:
Table of Contents
