Sony XVS-9000 User Manual page 362
Multi format switcher system
Hide thumbs
Also See for XVS-9000:
- User manual (569 pages) ,
- Service manual (204 pages) ,
- Technical manual (16 pages)
Table of Contents
Notes
• In macro only mode, it is not possible to set a macro
attachment.
• On a split fader, you can set a macro attachment to the
main fader lever (for background A bus).
1
Select the macro attachment register.
For details about the method of operation, see
"Setting the register to assign in a macro attachment"
(page 361).
2
Move the fader lever to the position where you want to
set the macro attachment.
3
Press and hold the [PRE MACRO] button or [POST
1)
MACRO] button
in the cross-point pad, and press the
[PRIOR SET] button or [LIMIT SET] button in the
control block containing the fader lever operated in
step 2.
1) Only when setting a macro attachment to the start point or end point
of fader lever operation, the use of the [PRE MACRO] and [POST
MACRO] buttons is different.
• To set the operation start point (0%): Press and hold the [PRE
MACRO] button.
• To set the operation end point (100%): Press and hold the [POST
MACRO] button.
This assigns the register set in step 1 to the fader lever
position selected in step 2.
To check macro attachment settings
Press and hold the [PRE MACRO] button or [POST
MACRO] button. While the button is pressed, the fader
lever position where the macro attachment is set appears in
the following places.
Transition indicator in the transition execution section:
The indicator lights at the position where the macro
attachment is set.
Transition rate indication in the transition execution
section: This shows the fader lever position where the
macro attachment is set, as a percentage value (fader
lever start position as 0%, end position 100%).
Removing macro attachment settings
To cancel a macro attachment to a button
Press and hold the [PRE MACRO] or [POST MACRO]
button in the cross-point pad and press the blinking 3rd
row cross-point button. The macro attachment setting is
canceled.
To cancel a macro attachment to a fader lever
Press and hold the [PRE MACRO] button or [POST
MACRO] button in the cross-point pad, and press the
[PRIOR SET] button or [LIMIT SET] button in the control
block containing the fader lever with the macro
attachment.
To delete individual macro attachment settings
You can delete individual settings of a macro attachment
assigned to a button.
1
Open the Macro >Attachment >Attachment menu
(5421).
2
Select the macro attachment setting you want to delete.
3
Press [Delete].
4
Check the message, then press [Yes].
To delete all macro attachment settings in a
single operation
1
Open the Macro >Attachment >Attachment menu
(5421).
2
Press [All Clear].
3
Check the message, then press [Yes].
Switching macro attachment assignment
mode (button number mode and pair
number mode)
When assigning a macro attachment to a cross-point
button, you can select button number mode or pair number
(video and key) mode.
Note
If you change the mode using the following procedure, all
macro attachment data relating to cross-point buttons is
lost.
1
Open the Macro >Attachment >Attachment menu
(5421).
2
In the group, select one of
the following.
Button Mode: Button number mode. Assign a macro
attachment for the combination of bus and button
numbers.
Pair Mode: Pair number mode. Assign a macro
attachment for the combination of bus and pair
numbers.
3
Check the message, then press [Yes].
Notes
• In pair number mode, carry out operations as follows.
- When a single pair number is assigned to multiple
cross-point buttons, pressing any of them executes the
macros of all cross-point buttons to which the same
362
Hide quick links:
Table of Contents
