Quick Links
RSEC3
User's Manual
Introduction
RADIOSENS system is designed for Fast doors and Flat-slat rolling shutters in an Industrial, Commercial or Residential environment.
RADIOSENS is an impact detection system installed at the principal edge of the door. It works detecting any obstacle before the
strength exceeds regulations limits and then inverting door movement.
RADIOSENS is a wireless system based on an RF transmitter and a receiver card plugged in the control panel which permanently
monitors the status of the transmitter programmed.
The RadioBand system is designed of domestic, commercial and industrial door applications where a safety edge is used.
The system complies with the EN ISO 13849-1 standard, category 2, PLc.
Technical data
Frequency
Memory
Standby / Operating consumption
Radiated power
Size
Range (in open field)
1248099_Rev1.0 RSEC3
Multifrequency system auto-adjustable 868 MHz
RS3: 1 transmitter;
RB3: 6 transmitters (3 on closing, 3 on opening)
Max 90mA
< 1mW
82 x 190 x 40 mm
50 metres
Page 1/4
GB
Summary of Contents for JCM Technologies RADIOSENS RSEC3
- Page 1 RSEC3 User’s Manual Introduction RADIOSENS system is designed for Fast doors and Flat-slat rolling shutters in an Industrial, Commercial or Residential environment. RADIOSENS is an impact detection system installed at the principal edge of the door. It works detecting any obstacle before the strength exceeds regulations limits and then inverting door movement.
- Page 2 Starting up Mechanical installation Connect the receiver to the control panel without power supply. Memorizing transmitter into receiver RS3 and RB3 systems are not compatible, so it cannot be stored in the same receiver. In addition, a transmitter may be memorized only in one receiver. Memorizing RS3 Receiver only keeps a RS3 transmitter in memory at the same time.
- Page 3 System programming After memorizing of the desired transmitter, perform the programming of the control panel with the security element memorized. See programming section on control panel user’s manual. Note: If you change the position of transmitter RS3, you must perform the system programming again, otherwise RS3 will indicate a safety error, and the door will not work properly.
-
Page 4: Ec Declaration Of Conformity
· System’s work frequency does not interfere with the 868 MHz remote control systems. JCM TECHNOLOGIES, S.A. declares herewith that the product RSEC3 complies with the relevant fundamental requirements as per Article 3 of the R&TTE Directive 1999/5/EG, and complies with the relevant fundamental requirements of the 2006/42/CE Machinery Directive, as well as with the ones of the 2004/108/CE Electromagnetic Compatibility Directive and 2006/95/CE Low Voltage Directive, insofar as the product is used correctly.