Table of Contents
1
WARNING
CAUTION
Installation
This chapter explains how to:
•
set up the equipment
•
adjust LO power levels
•
check mixer operation
•
perform final installation
This equipment is capable of radiating millimeter-wave energy from the end of
an unterminated waveguide. Do not look directly into the open end of any
waveguide when it is connected to a source of millimeter-wave energy.
Take precautions consistent with ANSI C95.1 - 1982, a study performed by the
American National Standards Institute that sets limits for human exposure to
microwave and millimeter-wave energy. Copies of this publication are available
from:
American National Standards Institute
11 West 42 Street
New York, New York 10036
Telephone: (212) 642-4900
WEB site: www.ansi.org
Do not connect LO power to the HP 11970 mixers until you adjust the LO
power in "Mixer LO Power Level Adjustment" on page 1-8. If you connect
LO power before adjusting it you could permanently damage the mixers.
HP 85325A Operating and Service Manual 1-1
Installation
Table of Contents
