Release Protocol Between Plc And Sinumerik Integrate; Contour Test - Siemens SINUMERIK 840D sl Function Manual
Sinumerik integrate amb, amc, amm
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
03/2013
2.3.6 Release protocol between PLC and SINUMERIK Integrate
Function description
During a test, there is communication between the SINUMERIK Integrate system
and the PLC. The system signals that a test with axis movements shall be
executed. The PLC puts the machine in a suitable state and signals to the system
that the test can be performed.
The protocol allows test series that are to be carried out with a maintenance
schedule to be executed in a fully automatic manner while being monitored by the
PLC.
2.3.7 Contour test
Function description
A dry run is possible to ensure measurements can safely be performed on the
machine. The machine operator has the option of executing a dry run with reduced
velocity before beginning the test run configured to a specific type. This allows the
operator to test for safety path motions (contour monitoring) of the machine axes to
avoid collisions, etc.
Fig. 2-42: Selecting the contour test
Note
Contour test:
Running-in the axis test - motion sequence, without data acquisition, in order to
ensure that there are no collisions. Stop start, operating mode and override may
be used as required.
© Siemens AG 2006-2013 All Rights Reserved
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
2 Machine information
2.3 Test series on the machine
2-69
Hide quick links:
Table of Contents
