GE Profile JP350AAAA Installation Instructions Manual

INSTALLATION INSTRUCTIONS FOR YOUR NEW

Before you begin—Read these instructions completely and carefully.

IMPORTANT—Save these instructions for local inspector's use.

IMPORTANT—OBSERVE ALL GOVERNING CODES AND ORDINANCES.

Note to Installer—Be sure to leave these instructions with the Consumer.

OWNER—Keep these instructions for future reference.

Note—This appliance must be properly grounded.

FOR YOUR SAFETY

CAUTION:

For Personal Safety remove house

STOP!

fuse or open circuit breaker before

beginning installation. Failure to do

so could result in serious injury or

even death.

• Be sure your cooktop is installed properly by a

qualified installer or service technician.

• To eliminate the risk of burns or fire by reaching over

heated surface elements, cabinet storage located

above the surface units should be avoided. If

cabinet storage space is to be provided, the risk can

be reduced by installing a range hood that projects

horizontally a minimum of 5" beyond the bottom of

the cabinets. Cabinet installation above the counter

unit may be no deeper than 13".

• The cooktop should be easy to reach and lighted

with natural light during the day.

• Always disconnect the electrical service to the unit

before repairing or servicing the counter unit. This

can be done by disconnecting the fuse or circuit

breaker.

Failure to do this could result in a

dangerous or fatal shock. Know where your main

disconnect switch is located. If you don't know,

have your electrician show you.

SR10239

Pub. No. 31-10147

4053P018-4

229C

30" ELECTRIC COOKTOP

• 1/8" drill bit

• Electric or hand drill

• Flat bladed screwdriver

• Pencil

• Ruler or tape measure and straightedge

• Hand or saber saw

ELECTRICAL REQUIREMENTS

This appliance must be supplied with the proper voltage

and frequency, and connected to an individual, properly

grounded branch circuit, protected by a circuit breaker

or time delay fuse, as noted on rating plate.

Wiring must conform to National Electrical Codes. You

can get a copy of the National Electrical Code, ANSI/

NFPA No. 70-Latest Edition by writing:

National Fire Protection Association

Batterymarch Park

Quincy, MA 02269

We recommend that you have the electrical wiring and

hookup of your counter unit done by a qualified

electrician. After installation, have the electrician show

you where your main disconnect is located.

The range connector block is approved for copper wire

connection only, and if you have aluminum house

wiring, you must use special UL approved connectors

for joining copper to aluminum.

You must use a three-wire, A.C. 208Y/120Volt or 120/

240 Volt, 60 Hertz electrical system. A white (neutral)

wire is not needed for this unit.

Refer to the rating plate on your unit for the K.W. rating

for your counter unit.

1

TOOL LIST