JCM Technologies 230START User Manual

230START / 230SOCKET

User's manual

Technical data

230Vac–1000VA plug controlled by radio.

Frequency

Coding

High security rolling code

Memory

Number of relays

Supply

Relay contacts

Consumption

Op. temperature

Watertightness

Size

58,5x104,50x50mm (without plugs)

Starting up

Connect the wired output (230START only).

It is recommended to program the receiver before installing (especially if the final location has difficult access).

Press the receiver programming button for 1 second and an acoustic signal will be heard and the led will turn on. The receiver will enter

programming. Press the transmitter to be programmed. Every time a transmitter is programmed, the receiver will issue an acoustic signal

for 0.5 sec. After 10 seconds without programming or pressing the first two transmitter buttons, the receiver will exit programming mode,

issuing two acoustic signals of 1 sec. If upon programming a transmitter the receiver memory is full, it will issue 7 acoustic signals of 0.5

seconds and exit programming.

In programming mode, press the reset button with a paperclip (or similar). The receiver will issue 10 short acoustic warning signals

followed by others at a faster pace to indicate that the operation has been successful. The receiver is now in programming mode.

After 10 seconds without programming or quickly pressing the programming button, the receiver will exit programming mode, issuing two

acoustic signals of 1 sec.

Operating

The led are activated every 5 seconds to indicate the correct supply of power to the equipment.

230START:

Upon receiving a code, the receiver checks whether it is in its memory, activating the wired output in an impulsional way. The 230V

output plug is always on.

230SOCKET:

Upon receiving a code, the receiver checks whether it is in its memory, activating the 230V output plug in a biestable way.

1248090_Rev1.0 230START/230SOCKET 

868,35MHz

30 codes

1 relays

230V ac (+/- 10%)

10A

Max 32mA

-20ºC to +55ºC

IP22

 

 

Page 1/2