Notes PLEASE READ THE FOLLOWING INSTRUCTION CAREFULLY BEFORE INSTALLATION: mal for indoor use. If it needs long-term outdoor work, please use canopy to protect it against rain. Install the device steadily on a smooth ground without vibration. Violent shaking may cause the device to report false alarms. Choose to install in areas away from high frequency devices and large mobile metals to avoid interference.
Parts 1. (Optional) Transparent rainproof canopy 2. Front beam 3. Rear beam 4. Host 5. Alarm zone LED 6. Infrared sensors 7. Waterproof foot cover 8. Power interface, power button, and reserved linkage interface Parts 3...
After reading the installation notes and checking the packing list items, follow the following steps to install. Step 1: Open the package and place the left and right door panel on the ground as shown below. 4 ZK-D4330 Installation Guide...
Page 9
Step 2: Connect the back beam with the left and right doors with bolts, as shown below. (Be careful not to tighten the bolts at this step) Installation 5...
Page 10
Step 3: Open the host beam cover as shown below. The removal tips of the beams is shown below. 6 ZK-D4330 Installation Guide...
Page 11
Step 4: Use the bolt to connect the front beam to the left and right door plate and tighten the left and right side bolts, as shown below. Installation 7...
Page 12
Step 5: Install the host on the adjustable metal bracket, the screws and holes on both sides of the adjustable metal bracket can be fixed and adjust the display Angle of the host, as shown below. 8 ZK-D4330 Installation Guide...
Page 13
Step 6: Pass the host signal line through the beam hole, as shown below. Installation 9...
Page 14
Step 7: Connect the host to the front beam with bolts, as shown below. (If you choose a waterproof cover, it can be installed together with host) Step 8: Plugs in and tightened the signal wire, as shown below. 10 ZK-D4330 Installation Guide...
Page 15
Step 9: Cover the beam,as shown below. The installation tips of the beams is shown below. Installation 11...
Page 16
Step 10: Lift the security door and move it to the designated position. Connect the power cord on the side of the door panel and press the power switch to enter the working state, as shown below. 12 ZK-D4330 Installation Guide...
Technical Parameters Input voltage: 100-240 V,50/60 Hz Working temperature: -20℃ ~ 50℃ External Dimensions (H x W x D): 2220 mm x 930 mm x 760 mm Channel Dimensions (H x W x D): 2010 mm x 760 mm x 760 mm Package Dimensions (H x W x D): 2300 mm x 335 mm x 800 mm Gross weight: 70 [kg] Technical Parameters 13...