Sony Xplod CDX-M730 Installation/Connections
Sony Xplod CDX-M730 Installation/Connections

Sony Xplod CDX-M730 Installation/Connections

Fm/mw/lw compact disc player
Hide thumbs Also See for Xplod CDX-M730:
3-242-100-31 (1)
FM/MW/LW
Compact Disc
Player
Installation/Connections
安裝 線路連接
CDX-M730
CDX-M630
Sony Corporation © 2002
Printed in Korea
1
1
2
3
4
× 4
8
5
6
7
× 2
Equipment used in illustrations (not supplied)
插圖中的裝置(非附送)
Front speaker
CD/MD changer
前揚聲器
CD/MD 換碟機
Active subwoofer
Rear speaker
有源超低音揚聲器
後揚聲器
Rotary commander RM-X4S
Power amplifier
旋轉式控制器 RM-X4S
功率放大器
2
A
AUDIO OUT
FRONT
SUB OUT (MONO)
AUDIO OUT
REAR
B
BUS AUDIO IN
BUS CONTROL IN
BUS AUDIO IN
Source selector*
音源選擇器*
XA-C30
BUS CONTROL IN
* not supplied
非附送
Cautions
Connection example (2)
• This unit is designed for negative earth 12 V
Notes (2-A)
• Be sure to connect the earth cord before
DC operation only.
connecting the amplifier.
• Do not get the wires under a screw, or caught
• If you connect an optional power amplifier and do
in moving parts (e.g., seat railing).
not use the built-in amplifier, the beep sound will
• Before making connections, turn the car
be deactivated.
ignition off to avoid short circuits.
• Connect the yellow and red power input leads
Tip (2-B-
)
only after all other leads have been connected.
For connecting two or more CD/MD changers, the
• Run all earth wires to a common earth
source selector XA-C30 (optional) is necessary.
point.
• Be sure to insulate any loose unconnected
wires with electrical tape for safety.

Connection diagram (3)

Notes on the power supply cord (yellow)
• When connecting this unit in combination with
1
To a metal surface of the car
other stereo components, the connected car
First connect the black earth lead, then connect
circuit’s rating must be higher than the sum of
the yellow and red power input leads.
each component’s fuse.
2
To the power aerial control lead or power
• When no car circuits are rated high enough,
supply lead of aerial booster amplifier
connect the unit directly to the battery.
Notes
• It is not necessary to connect this lead if there
is no power aerial or aerial booster, or with a
manually-operated telescopic aerial.
• When your car has a built-in FM/MW/LW aerial
in the rear/side glass, see “Notes on the control
Parts Iist (1)
and power supply leads.”
3
To AMP REMOTE IN of an optional power
The numbers in the list are keyed to those in the
amplifier
instructions.
This connection is only for amplifiers. Connecting
any other system may damage the unit.
For the use of release key 8, see the supplied
4
To the interface cable of a car telephone
operating instructions.
5
To a car’s illumination signal
Be sure to connect the black ground lead to it
Caution
first.
6
To the +12 V power terminal which is energized
Handle the bracket 1 carefully to avoid injuring
in the accessory position of the ignition key
your fingers.
switch
Notes
• If there is no accessory position, connect to the
+12 V power (battery) terminal which is
energised at all times.
Be sure to connect the black earth lead to it
first.
• When your car has a built-in FM/MW/LW aerial
in the rear/side glass, see “Notes on the control
and power supply leads.”
7
To the +12 V power terminal which is energised
at all times
Be sure to connect the black earth lead to it first.
loading

Summary of Contents for Sony Xplod CDX-M730

  • Page 1: Connection Diagram

    FM/MW/LW Compact Disc Player Installation/Connections 安裝 線路連接 CDX-M730 CDX-M630 Sony Corporation © 2002 Printed in Korea × 2 Equipment used in illustrations (not supplied) 插圖中的裝置(非附送) Front speaker 前揚聲器 Rear speaker 後揚聲器 Power amplifier 功率放大器 3-242-100-31 (1) Cautions • This unit is designed for negative earth 12 V DC operation only.
  • Page 2 BUS AUDIO IN from car aerial 來自汽車天線 SUB OUT (MONO) AMP REM Max. supply current 0.3 A 最大供電量 0.3 A Left 左 Right 右 Left 左 Right 右 Notes on the control and power supply leads • The power aerial control lead (blue) supplies +12 V 注意...
  • Page 3 CDX-M730 CDX-M630 Extended portion of the front panel Extended portion of the front panel 前面板的伸出部分 前面板的伸出部分 20 mm 7.2 mm 7 mm Bend these claws outward for a tight fit, if necessary. 若有必要,則可向外彎曲這些卡爪, 以便牢固安裝。 TOYOTA max. size 5 × 8 mm 最大尺寸...
  • Page 4 You may not be able to install this unit in some driving operations. makes of Japanese cars. In such a case, consult •Avoid installing the unit in areas subject to your Sony dealer. dust, dirt, excessive vibration, or high temperatures, such as in direct sunlight or near Note heater ducts.

This manual is also suitable for:

Cdx-m630