Internally Processed M Codes; Macro Call Via M Function - Siemens Sinumerik 802D sl Programming Manual
Iso turning
Hide thumbs
Also See for Sinumerik 802D sl:
- Function manual (462 pages) ,
- Programming and operating manual (364 pages) ,
- Instruction manual (262 pages)
Table of Contents
04.07
M30 (end of tape)
Normally, M30 is specified at the end of tape. When M30 is executed during auto-
matic operation, automatic operation ends after the commands specified with M30
in the same block have been completed. The NC is reset and the tape is rewound.
The state after the execution of M30 varies with each machine. For details, refer to
the instruction manuals published by the machine tool builder.
Notice
When M00, M01, M02, or M30 is specified, the NC stops buffering. For these M
codes, the NC output the independent decode signal in addition to the M2-digit
BIN code.
Notice
Refer to the manuals published by the machine tool builder concerning whether or
not the spindle and/or coolant supply is stopped by the M00, M01, M02, and M30.
3.7.2
Internally processed M codes
M codes in the range of M98 and M99 are processed by the NC.
Table 3-10
M98
M99
3.7.3
Macro call via M function
Similar to G65, a macro can be called via M numbers.
The 10 M-function replacement is configured via machine data
10841: $MN_EXTERN_M_NO_MAC_CYCLE and
10815: $MN_EXTERN_M_NO_MAC_CYCLE_NAME.
The parameters are transferred as with G65. Repeat procedures can be program-
med with address L.
© SIEMENS AG 2007 All rights reserved
SINUMERIK 802D sl/840D sl840D/840Di sl/840Di/810D ISO Turning - - 04.07 Edition
Internally processed M codes
M code
Subprogram call
End of subprogram
Movement Control Commands
3.7 Miscellaneous function (M function)
Function
3-85
Hide quick links:
Table of Contents
