Precision 132 - Cisco Nexus 7000 Series Command Reference Manual
Nx-os ip service level agreements slas
Hide thumbs
Also See for Nexus 7000 Series:
- Command reference manual (1018 pages) ,
- Reference manual (746 pages) ,
- Configuration manual (536 pages)
Table of Contents
Chapter 1
Cisco Nexus 7000 Series IP SLAs Commands
precision
To set the level of precision at which the statistics for a Cisco NX-OS IP Service Level Agreements
(SLAs) operation are measured, use the precision command. To return to the default value, use the no
form of this command.
Syntax Description
milliseconds
microseconds
Command Default
Measurements for the IP SLAs operation are displayed in milliseconds.
Command Modes
IP SLA configuration mode
UDP jitter configuration mode (config-ip-sla)
Command History
Release
6.1(1)
Usage Guidelines
If the milliseconds keyword is configured (default), the measurements for an IP SLAs operation are
displayed with the granularity of 1 ms. For example, a value of 22 equals 22 ms. If you use the
microseconds keyword, the measurements for an IP SLAs operation are displayed with the granularity
of 1 microsecond. For example, a value of 202 equals 202 microseconds.
This command is supported by the IP SLAs User Datagram Protocol (UDP) jitter operation only.
Examples
This example shows how to enable microsecond precision, configure the Network Time Protocol (NTP)
synchronization offset tolerance to 10 percent, and set the packet priority to high for an IP SLAs UDP
jitter operation.
switch(config)# ip sla 1
switch(config-ip-sla)# udp-jitter 192.168.202.169 9006
switch(config-ip-sla-jitter)# precision microseconds
switch(config-ip-sla-jitter)# clock-tolerance ntp oneway percent 10
switch(config-ip-sla-jitter)# ip sla schedule 1 life forever start-time after 00:00:06
switch(config)#
Related Commands
Command
show ip sla auto group Displays the configuration including default values of IP SLAs auto-measure
OL-27555-03
precision {millisecond | microseconds}
no precision
Sets the precision of IP SLAs operation measurements to 1 millisecond (ms).
Sets the precision of IP SLAs operation measurements to 1 microsecond
(usec).
Modification
This command was introduced.
Description
groups.
Cisco Nexus 7000 Series NX-OS IP Service Level Agreements (SLAs) Command Reference
precision
1-33
Table of Contents
