Honeywell ADEMCO 5801 Installation And Setup Manual

PLEASE SEE FCC / IC

STATEMENTS AT

BOTTOM OF PAGE 2

INSTALLATION AND SETUP GUIDE

GENERAL

The ADEMCO 5801 is a portable unit, which can be programmed (at the control

receiver) to perform up to four system functions (e.g., arm STAY, arm AWAY, Panic,

disarm, etc.). No audible or visual system status indications are provided by the 5801

(except for a Red LED indicator which flashes when the unit transmits). The 5801 is

intended for use only with wireless alarm systems that support 5800 series devices.

The transmitter may be left unmounted, resting on a table, countertop, or other surface,

or carried in a pocket or purse. If the unit will not be wall-mounted, remove the mounting

plate attached to the back of the unit (see step 1 of WALL-MOUNTING instructions on

the other side)

Ensure that a transmission is received from each area where usage of this transmitter is

anticipated.

PROGRAMMING

The 5801 has four unique identification codes permanently assigned during

manufacture. You must "enroll" these codes into the control system at some point prior

to usage of the system. Each button must be enrolled by the control receiver. See

Important Note below.

IMPORTANT PROGRAMMING NOTE:

PROGRAMMED AS ONE OF THE FOLLOWING INPUT TYPES ONLY:

"UR" type (unsupervised RF) or "RF" type (supervised RF)

The UR type is supervised only for battery status, whereas the RF type is supervised for

an hourly check-in signal and must not be taken out of range of the control receiver.

See the control unit's Installation Instructions for further details regarding programming.

SELECTION OF FUNCTIONS FOR BUTTONS

For convenience, the 5801 is supplied with the buttons labeled with the functions shown

in Figure 1. Labels for these particular functions were chosen since they are

those likely to be selected for most

installations.

However,

labels are provided for those cases

where other functions are desired;

simply attach the new label over the

existing one. In all cases, each

button must be programmed for its

desired function, as indicated in the

control unit's installation instructions.

IMPORTANT NOTE:

If the "Function 4" button is not

used, it MUST be programmed as

a "Not used" zone type.

Remote Wireless Panic Transmitter

THE 5801 TRANSMITTER MUST BE

additional

FUNCTION

3

FUNCTION

4

Figure 1. 5801 Transmitter

N6478V3 5/05 Rev. B

ADEMCO 5801

LED

FUNCTION

2

AWAY

STAY

OFF

PANIC

FUNCTION

1