Related Manuals for Beko BWH 50 LED
Summary of Contents for Beko BWH 50 LED
- Page 1 Storage Electric BWH 50 LED Water Heater BWH 80 LED User Manual BWH 100 LED...
-
Page 2: Table Of Contents
General Remark ● The installation and maintenance has to be carried out by qualified professionals or Midea authorized technicians. ● The manufacturer shall not be held responsible for any damage or malfunction caused by wrong installation or failing to comply with following instructions included in this pamphlet. ●... -
Page 3: Cautions
1. CAUTIONS Before installing this water heater,check and confirm that the earthing on the supply socket is reliably grounded. Otherwise, the electrical water heater can not be installed and used. Do not use extension boards. Incorrect installation and use of this electrical water heater may result in serious injuries and loss of property. -
Page 4: Product Introduction
● If any parts and components of this electrical water heater are damaged please contact customer care center for repair. ● This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. - Page 5 2.3 Brief introduction of product structure Thermometer Shell Inner tank Thermal insulation Heating element Anode Temperature On/ Off adjusting knob Power indicator Cold water inlet light Heating indicator light Hot water outlet D30-20Z1 D50-20Z2 D80-20Z3 D100-20Z3 (Note:All dimensions are in mm) 2.4 Internal Wire Diagram Thermal Cut Out...
-
Page 6: Unit Installation
3. UNIT INSTALLATION 3.1 Installation Instruction This electrical water heater shall be installed on a solid wall. If the strength of the wall cannot bear the load equal to two times of the total weight of the heater filled fully with water, it is then necessary to install a special support. - Page 7 3.2 Pipelines Connection The dimension of each pipe part is G1/2” ; The massive pressure of inlet should use Pa as the unit; The minimum pressure of inlet should use Pa as the unit. Connection of pressure relief valve with the heater on the inlet of the water heater. In order to avoid leakage when connecting the pipelines, the rubber seal gaskets provided with the heater must be added at the end of the threads to ensure leak proof joints (see Fig.4).
-
Page 8: Methods Of Using
NOTE Please be sure to use the accessories provided by our company to install this electric water heater. This electric water heater can not be hung on the support until it has been confirmed to be firm and reliable. Otherwise, the electric water heater may drop off from the wall, resulting in damage of the heater, even serious accidents of injury. -
Page 9: Troubleshooting
● The water heater is equipped with a thermal switch, which cuts off power supply of the heating element upon water overheating or its absence in the water heater. If the water heater is connected to the mains, but water is not heated and the indicator doesn’t light up, then the thermal switch was switched off or not switched on. - Page 10 www.beko.com...