Cisco MDS 9000 Series Configuration Manual page 283
Hide thumbs
Also See for MDS 9000 Series:
- Command reference manual (1464 pages) ,
- Configuration manual (308 pages) ,
- Troubleshooting manual (161 pages)
Table of Contents
Configuring FICON
switch# setup ficon
This setup utility will guide you through basic Ficon Configuration
on the system.
Press Enter if you want to skip any dialog. Use ctrl-c at anytime
to skip all remaining dialogs.
Step 2
Enter yes (the default is yes) to enter the basic FICON configuration setup.
Would you like to enter the basic configuration dialog (yes/no) [yes]: yes
The FICON setup utility guides you through the basic configuration process. Press Ctrl-C at any prompt to end the
configuration process.
Step 3
Enter the VSAN number for which FICON should be enabled.
Enter vsan [1-4093]:2
Step 4
Enter yes (the default is yes) to create a VSAN.
vsan 2 does not exist, create it? (yes/no) [yes]: yes
Step 5
Enter yes (the default is yes) to confirm your VSAN choice:
Enable ficon on this vsan? (yes/no) [yes]: yes
At this point, the software creates the VSAN if it does not already exist.
Note
Step 6
Enter the domain ID number for the specified FICON VSAN.
Configure domain-id for this ficon vsan (1-239):2
Step 7
Enter yes (the default is no) to set up FICON in cascaded mode. If you enter no, skip to step 8 (see the
Management, on page
Would you like to configure ficon in cascaded mode: (yes/no) [no]: yes
a) Assign the peer WWN for the FICON: CUP.
Configure peer wwn (hh:hh:hh:hh:hh:hh:hh:hh): 11:00:02:01:aa:bb:cc:00
b) Assign the peer domain ID for the FICON: CUP
Configure peer domain (1-239) :4
c) Enter yes if you wish to configure additional peers (and repeat Steps 7a and 7b). Enter no, if you do wish to configure
additional peers.
Would you like to configure additional peers: (yes/no) [no]: no
Step 8
Enter yes (the default is yes) to allow SNMP permission to modify existing port connectivity parameters (see the
Configuring SNMP Control of FICON Parameters, on page
Enable SNMP to modify port connectivity parameters? (yes/no) [yes]: yes
--- Ficon Configuration Dialog ---
289).
267).
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
Setting Up a Basic FICON Configuration
CUP In-Band
261
Table of Contents
