Brother DCP-J4110DW Service Manual page 110
Inkjet printers
Hide thumbs
Also See for DCP-J4110DW:
- Basic user's manual (123 pages) ,
- Quick setup manual (41 pages) ,
- Guía del usuario de software manual (246 pages)
Table of Contents
Separated lines over the whole page
Step
1
Head inclination is not correctly
adjusted.
2
Head correction uncompleted
3
Paper feeding correction value not
updated
4
PF encoder disk stained
5
Non-discharge of ink from head
6
PF encoder disk defective
7
Head defective
8
Main PCB defective
Overlapping lines at the trailing edge of the recording paper
Step
1
Paper feeding correction value not
updated
2
PF encoder disk stained
3
PF encoder disk defective
4
Main PCB defective
User Check
- Carry out head cleaning.
Cause
Adjust the head inclination (refer to
Section
Input the head correction data (refer to
Section
Adjust the paper feeding correction value (refer to
Chapter 5, Section
Clean the PF encoder disk and flushing guide (refer
to
Perform the recommended purge procedures.
Refer to "Recommended purge procedures" in
Chapter 5, Section 1.3.29 "Purge Operation
(Maintenance mode 76)."
Replace the PF encoder disk.
Replace the head/carriage unit.
Replace the main PCB ASSY.
User Check
- Carry out head cleaning.
Cause
Adjust the paper feeding correction value (refer to
Chapter 5, Section
Clean the PF encoder disk and flushing guide (refer
to
Replace the PF encoder disk.
Replace the main PCB ASSY.
2-73
Solution
2.4.)
1.3.25.)
1.3.19.)
Chapter 3, Section
1.)
Solution
1.3.19.)
Chapter 3, Section
1.)
Chapter 4,
Chapter 5,
Confidential
Chapters
Table of Contents
Troubleshooting
