Related Manuals for Acoustech H-100II
Summary of Contents for Acoustech H-100II
- Page 3 H-100II. UNPACKING Remove the H-100II carefully from its carton to prevent any scuffing or scratching. Take a moment to inspect for any shipping damage. If you discover shipping damage, please contact your dealer and the shipping company immediately.
- Page 4 H-100II AMPLIFIER PANEL DRAWING B - Amp rear panel...
- Page 5 H-100II AMPLIFIER PANEL 1. POWER INDICATOR LED – When the subwoofer is ON, this LED light will be green. When the subwoofer is in the STANDBY mode, it will be red. 2. POWER/AUTO ON SWITCH – This toggle switch turns the subwoofer on and off. When the switch is in the OFF position, the subwoofer will not play.
- Page 6 - If you prefer a wireless connection rather than using a subwoofer cable, you can connect your H-100II wirelessly to your digital receiver with a BIC WTR-SYS kit. You can also add an unlimited amount of wireless H-100II subs to your system by adding BIC W-Receivers. Please contact BIC sales at 877-558-4242, ext. #1 for more information.
- Page 7 CROSSOVER FRE- QUENCY CONTROL (#5) on the back of your H-100II (also see Page 5, #5). In most cases, setting the crossover to the 90Hz set- ting on the control will yield the best results.
- Page 9 INITIAL LISTENING TEST It’s now time to test the H-100II subwoofer in your listening environment. 1. Before turning your stereo system and subwoofer on, double-check all connections. 2. Turn the volume controls on both the subwoofer and your audio receiver all the way down (fully counterclockwise) and check that the PHASE SWITCH is set to 0°...
-
Page 10: Troubleshooting Guide
TROUBLESHOOTING GUIDE If you are having a problem with your subwoofer, please read through this “Trouble Shooting Guide”. Many times problems are actually caused by other items in the system or the subwoofer’s interaction with those items. These problems can easily be resolved with this guide. - Page 11 Problem Cause Solution • Make sure the switch on the back of the sub is in the “ON” position. AC power is not getting to the • Check that you are using the correct power cord and that amplifier. 4) NO OUTPUT it is plugged in securely at both ends and make sure that the FROM SUB AC outlet the subwoofer is plugged into is working.
-
Page 12: Warranty Information
Exclusion of Certain Damages B . I . C America’s liability for any defective product is The H-100II enclosure is finished in a very high quality limited to repair or replacement of the product at our polymer laminate covering that is both attractive and option.