Breas Z1 Getting Started Manual

1. With both the Z1 and the battery fully

inserted into the PowerShell, plug the power

supply (AC to DC Adapter) as shown in the

wall outlet. The Z1 must be in standby mode

(display reads

) to charge the battery.

The Z1 can be removed from the PowerShell by pressing the two ( ) icons on the sides of the

PowerShell and sliding the Z1 out. The battery can be removed from the PowerShell by the two

blue buttons on the battery shuttle and sliding the battery out.

NOTE: If the PowerShell does not appear to be charging, disconnect Z1, battery, and power supply

and reassemble. Make sure you hear the components click together and see that the DC plug (silver

cylinder in the bottom of PowerShell) goes into the hole in the CPAP and then reattempt to charge the

PowerShell.

If you encounter other problems consult the Z1 User Guide or contact the Support Center

toll-free at 1-855-436-8724.

Designed and assembled in the United States of America.

Breas Medical, Inc. N. Billerica, MA 01862

PowerShell®, Z1® and the HDM logo are registered trademarks of Breas Medical, Inc. N. Billerica, MA 01862, USA.

US Patent Pending. © Copyright 2014-2018, Breas Medical AB. All rights reserved.

2. The battery status indicator on the Z1

(

) will flash when the battery is charging.

The number of solid bars indicates the

current level of charge. The battery charging

is complete when the 4th bar stops flashing.

x

PowerShell Getting Started v1 08152018

40-0012 Rev. C

®

PowerShell

with Extended Life Battery

Getting Started Guide