Table of Contents
Troubleshooting (concerning the finisher)
Check the list below before contacting the SHARP Service Center.
Problem
Stapling position is
Stapling position not set properly in the
not correct.
stapling setting?
The finisher does
The finisher is open or the top cover, front
not operate.
cover or paper guide of the finisher open?
Message indicating need to remove paper
from the stapler compiler displayed?
Stapling cannot be
Message requesting check for the staple
performed.
unit displayed?
Message requesting adding staples
displayed?
Different size paper included?
Paper heavily curled?
Solution
Check the stapling position setting. (See page xx.)
Close all covers. (See pages xx and xx.)
Remove all paper from the stapler compiler following
the procedure described in step 1 on page xx.
Remove jammed staples. (See page xx.)
Replace the staple cartridge. (See page xx.)
Stapling cannot be performed onto different size
paper.
Paper may be curled heavily depending on the paper
type and quality. Remove paper from the paper tray
or the bypass tray, turn it upside down, and load it
again.
FINISHER
5
5-15
Chapters
Table of Contents
Troubleshooting
