Adjustment With The System Setup Menu; Adjustment With The Auto Iris Setup Menu - Sony BVP-900 Series System Manual
Video camera system
Hide thumbs
Also See for BVP-900 Series:
- Product information manual (140 pages) ,
- Maintenance manual (520 pages) ,
- Operation manual (48 pages)
Table of Contents
7-3-10 Adjustment With the
System Setup Menu
By pressing the MIC 1 LEVEL control with the cursor
set at "System Setup" on the Maintenance menu (page
7-11), the System Setup menu appears.
System Setup menu
* System Setup *
Camera No.
Filter Local
Gain SW Low : 0dB
Gain SW Mid : 6dB
Gain SW High: 12dB
The values obtained in the L, M and H settings of the
gain switch can be selected on the System Setup menu
in advance.
To select the Gain Switch Values
Operating procedure
1
Set the cursor to the item to be adjusted by turning
the MIC 1 LEVEL control, then press the control.
Gain SW Low: Gain value for the L setting of the
GAIN Switch
Gain SW Mid: Gain value for the M setting of the
GAIN Switch
Gain SW High: Gain value for the H setting of the
GAIN Switch
2
By turning the MIC 1 LEVEL control, select a gain
value for the position selected in step 1.
3
When the adjustment is completed, press the
ENTER/CANCEL switch downward to CANCEL
to return to the Maintenance menu.
Underfined
Enable
7-3-11 Adjustment With the Auto
Iris Setup Menu
By pressing the MIC 1 LEVEL control with the cursor
set at "Auto Iris Setup" on the Maintenance menu
(page 7-11), the Auto Iris Setup menu appears.
Auto Iris Setup menu
* Auto Iris Setup *
Level
APL Ratio : B2
The the convergence target and APL ratio for the
automatic iris adjustment can be adjusted using the
Auto Iris Setup menu.
To adjust the Auto Iris values
Operating procedure
1
Set the cursor to the item to be adjusted by turning
the MIC 1 LEVEL control, then press the contol
Level
Turn the left-most control to determine the
convergence target of the automatic iris adjustment.
The higher you set the value, so is the level.
APL (Average Picture Level) Ratio
Turn the second control from the left to determine
if the feedback is to be applied according to the
peak luminance of the object or the average
luminance.
The higher you set the value, the feedback depends
more on the average luminance.
Set value
–99
Peak-to-Average
1:0
2
Adjust the item selected in step 1 by turning the
MIC 1 LEVEL control.
3
Repeat steps 1 and 2 as required.
4
When the adjustments are completed, press the
ENTER/CANCEL switch downward to ENTER to
return to the Maintenance menu.
Chapter 7 Stand-Alone Operations of Cameras, etc.
: 0
0
+99
1:1
0:1
7-17
Table of Contents
