Honeywell SiX Series Installation Instructions
  1. Manuals
  2. Brands
  3. Honeywell Manuals
  4. Accessories
  5. SiX Series
  6. Installation instructions
Honeywell SiX Series Installation Instructions

Honeywell SiX Series Installation Instructions

3-zone wireless shock/door/window sensor
Hide thumbs Also See for SiX Series:
1
2
3
4

Quick Links

SiXSHOCK
Wireless Shock/Door/Window Sensor

Installation Instructions

The SiXSHOCK is a 3-zone wireless
shock/door/window sensor is intended for use with
Honeywell controls that support SiX™ series
devices.
It provides
• Reed switch/magnet zone
• External wired contact zone
• Built-in shock sensor zone
Typical shock protection area:
10 - 12 sq. ft. / 5 - 6 foot radius (3.05m – 3.66m /
1.52m – 1.83m radius)
The coverage area can vary depending on the
mounting surface.
Open the SiXSHOCK
Firmly slide the top and bottom housings in
opposite directions and pull them apart to open the
device.
Installation Options
The SiXSHOCK can be mounted with several
options:
• Loop 1: Built-in shock sensor alarm status
• Loop 2: Normally closed, built in reed switch,
used with the included magnet (1)
• Loop 3: Externally wired, closed-circuit contact
loop connected to the Terminal Block
NOTE:Wiring limit is 3ft.
Gap specifications:
a. Make gap is at least 0.8" (1)
b. Break gap is at least 0.95" (1)
(reduced about 30% for steel)
loading

Need Assistance?

Do you have a question about the SiX Series that isn't answered in the manual? Leave your question here.

Error while submitting your question. Please, reload page and try again.

Thank you! Your question has been received!

Related Manuals for Honeywell SiX Series

Summary of Contents for Honeywell SiX Series

  • Page 1: Installation Instructions

    SiXSHOCK Wireless Shock/Door/Window Sensor Installation Instructions The SiXSHOCK is a 3-zone wireless shock/door/window sensor is intended for use with Honeywell controls that support SiX™ series devices. It provides • Reed switch/magnet zone • External wired contact zone • Built-in shock sensor zone Typical shock protection area: 10 - 12 sq.
  • Page 2 Mounting TheSiXSHOCKsensor MUST be mounted as follows: • On swinging doors: mount on upper corner, opposite hinge is ideal • On sliding windows and doors: on the frame (on moving section when magnet is used) Double sided tape and screws provided for mounting.

  • Page 3: Led Indications

    • Remove the battery, wait 10 seconds, then insert a new battery. Recommended batteries: Duracell DL123A Honeywell 466 Huiderui CR123A Panasonic CR123A • Place the front and back housings together and slide them together. BATTERY CAUTION: Risk of fire, explosion and burns.

  • Page 4: Specifications

    Specifications Approval Listings: Battery: 1 x 3V Lithium, Honeywell 466, Panasonic CR123A, FCC / IC Duracell DL123A or Huiderui CR123A cETLus Listed Conforms to UL 634 Tamper: Cover and Wall Certified to ULC/ORD-C634 RF Frequency: 2.4GHz Other Standards: Operating Temperature: 32° – 122° F / 0° – 50° C RoHS (Agency Compliance 32°...

This manual is also suitable for:

Sixshock