Bosch WAT28400UC Use And Care Manual / Installation Instructions
  1. Manuals
  2. Brands
  3. Bosch Manuals
  4. Washer
  5. wat28400uc
  6. Use and care manual / installation instructions

Bosch WAT28400UC Use And Care Manual / Installation Instructions

Hide thumbs Also See for WAT28400UC:
Table of Contents

Quick Links

See also: Use and Care Manual
en-us Use and Care Manual, Installation Instructions
Washer
WAT28400UC
Table of Contents
loading

Related Manuals for Bosch WAT28400UC

Summary of Contents for Bosch WAT28400UC

  • Page 1 Use and Care Manual, Installation Instructions Washer WAT28400UC...

  • Page 2: Installation Instructions

    If front of the appliance is covered ventilation openings Under counter (Less Desirable) must be installed. E & F are minimum area sizes 63 sq.in. 404 sq.cm 63 sq.in. 404 sq.cm G & H actual spacing dimensions for min. open area sizes 3 in.

  • Page 3: Tools Needed

    Tools needed Parts provided with your washer The following tools may be helpful during installation of Back side of the washing mashine your washer. 13mm socket for removing the transport bolts. ▯ 17mm wrench for adjusting the appliance feet. ▯ Bubble level for leveling the appliance.

  • Page 4: Set Up On A Pedestal With Drawer

    NOTICE: If any parts are missing please notify your floor dealer immediately. Your new Bosch washing machine utilizes high spin speeds to achieve superior water removal from your Set up on a pedestal with drawer laundry resulting in reduced drying time. It is important to...

  • Page 5: Remove The Transport Bolts

    Remove the transport bolts Place covers over the transport bolt holes Four plastic covers are provided in the small parts bag included with your washer. Separate these covers and CAUTION install one in each hole where the transport bolts were removed.
  • Page 6 The water supply pressure must be between 14,5 to Water drain hose connection ▯ 145 psi (1 - 10 bar) with a minimum of 2.2 U.S. gallons NOTICES (8 liters) of flow per minute. A pressure regulator valve Do not reuse an old drain hose. Only use the drain must be installed if the maximum water pressure is ▯...

  • Page 7: Leveling The Washer

    Press down on each corner of the washer top to make Wash Basin sure the washer doesn’t “wobble“. There should be no "give" or movement. All four washer feet should press WARNING equally against the floor. This is just as important as the washer being level to prevent vibration.
  • Page 8 See the table below for connection specfications and WARNING fuse/breaker requirements. ELECTRICAL SHOCK HAZARD Volts Hertz Ampers Watts To reduce the risk of electrical shock: 2.880 max. Only pull out the power cord by the plug end and ▯ never by the cable, as this could damage it. The wiring for the electrical outlet circuit must be Never touch or hold the plug end or power cord ▯...

  • Page 9: Transporting The Washer

    Transporting the washer Insert the transport bolt assemblies Before transporting the washer Disconnect the washer power cord from the wall outlet. Turn off the water supply to the washer. Disconnect water supply lines from the tap. Disconnect the drain hose from the drain location. Install the transport bolt assemblies as shown in the following images.

Table of Contents