Electronic Modules For Id Key-Operated Switches - Siemens SIRIUS ACT 3SU1 System Manual

Industrial controls, command and signaling devices pushbuttons and signaling devices
Table of Contents
8.1.17

Electronic modules for ID key-operated switches

The electronic modules for ID key-operated switches are designed for use with the ID key-
operated switch. The electronic modules for ID key-operated switches can be installed in a
3SU18.1-1AA00-1AA1 enclosure for one command point, or in a front plate using 3-slot
holders. The 3SU1400-1GD10-1AA0 electronics modules for ID key-operated switches can
be parameterized via IO-Link.
The version of electronic modules for ID key-operated switches with IO-Link
(3SU1400-1GD10-1AA0) satisfies the maximum emission limit values on the basis of the
following rules:
● For the USA:
$15.201(a) devices under 490 kHz, where all emissions are at least 40 dB under the limit
value according to $15.209.
● For Canada:
RSS-310, Edition 4, July 2015 Chapter 3.7
Transmitters with a basic emission under 490 kHz and for which it has been certified that
all of the emissions are at least 40 dB under the general field intensity limits listed in
RSS-Gen must correspond to the general provisions of RSS-310 and the applicable
provisions of RSS-Gen.
This device corresponds to the RSS-310 of Industry Canada. Its operation is subject to
the condition that this device must not cause any radio interference and is protected from
interference that can lead to undesired operation of the device.
For the installation you must use the plastic holder (3SU1500-0AA10-0AA0).
For further information on the devices, refer to Chapters "ID key-operated switches
(Page 88)", "ID keys (Page 415)" and "Technical data (Page 439)".
You can find information on using the electronic modules for ID key-operated switches for
IO-Link in Chapter "IO-Link 3SU14 (Page 303)".
Article numbers
Siemens Industry Mall
(http://mall.industry.siemens.com/mall/en/WW/Catalog/Products/10221530)
SIRIUS ACT 3SU1 pushbuttons and signaling devices
System Manual, 08/2018, A5E03457306020A/RS-AK/010
IO-Link protocol
Power supply via
supported
IO-Link master
No
---
Yes
Yes
IO-Link transfer
Article number
rate
---
3SU1400-1GC10-1AA0
COM2
3SU1400-1GD10-1AA0
(38.4 kBaud)
3SU14 modules
8.1 Overview
195

Hide quick links:

Table of Contents
loading

Table of Contents