Summary of Contents for Honeywell DT8016MF4 DUAL TEC
Page 1
DT8016MF4 / DT8016MF5 DUAL TEC Motion Sensor – Installation Instructions ® QUICK LINKS Mounting Location Guidelines Wiring Examples Troubleshooting Open the Sensor Walk Test the Sensor Sensor Specifications Mount the Sensor Detection Patterns Accessories Sensor Components and Settings Remote LED Enable Approval Listings Wire the Sensor Relay Operation...
Page 2
See wiring details and examples on page - 2 -...
WIRING DETAILS - Observe proper polarity. Notes: - If not using the integrated EOL resistors, set all switches to - Consult the Control Panel manual to determine proper EOL selection. OFF. - The Alarm, Tamper and Trouble EOL settings must - If using the integrated EOL resistors: each only have one switch ON.
Flashlight Feature: 1. Use a flashlight with a bright light beam, and stand within 1.2 m (4’) of the sensor. 2. Swing the light beam past the sensor IR window 3-5 times, holding the beam on the window for 0.5 second each pass. The flashlight feature is only available for the first 24 hours after the first power up.
PIR White Light Immunity: 10,000 Lux typical CNPP Cert. : www.cnpp.com et AFNOR Cert.: www.marque-nf.com Fluorescent light filter: 50 Hz / 60 Hz. DT8016MF4 Honeywell Security Group - BP1219 Operating Temperature: -10° to 55° C INCERT B-893-0014 1198 avenue du docteur Maurice Donat Sophia Antipolis Relative Humidity: 5 to 95%;...
Page 6
Please contact your local authorised Honeywell representative for product warranty information. 2013 Honeywell International Inc. Honeywell and DUAL TEC are registered trademarks of Honeywell International Inc. All other trademarks are the properties of their respective owners. All rights reserved.