Related Manuals for AEQ AM-03
Summary of Contents for AEQ AM-03
- Page 1 AEQ AM-03 Self-powered Stereo Audio Monitor USER’S MANUAL ED. 10/06 V. 1.1 - 14/05/2014...
-
Page 2: Table Of Contents
4.3.5. MONOAURAL SIGNAL IN PHASE 4.3.6. STERIO SIGNAL OUT OF PHASE 4.3.7. MONOAURAL SIGNAL OUT OF PHASE 4.4. MONOTORING WITH HEADPHONES 4.4.1. HEADPHONES CONNECTION 5. DESCRIPTION OF AM-03 FRONT AND BACK PANNELS 5.1. FRONT PANEL 5.2. BACK PANEL 6. TECHNICAL SPECIFICATIONS 6.1. -
Page 3: Miscellaneous
1.1.2. Power and Ground connection To reduce the electrical shock risk, the AM-03 must to be connected to ground. The unit is supplied with the ground plug connector. If necessary to change the plug, the ground wire is the yellow/green one. - Page 4 The maintenance operations of this units should be carried out exclusively by qualified technical service. AEQ is not liable to any damage caused to the equipment due to any maintenance operation without our authorization, neither to the damage that an equipment repaired without such authorization could inflict to other equipment or persons.
- Page 5 -to its effect- an AEQ Sales office or the Technical Service of AEQ within thirty days of the appearance of the defect and within the period of guarantee, as well as to facilitate a copy of the purchase invoice and serial number of the product.
-
Page 6: Power Requirements
2.1.1. Connecting the equipment to mains The AM-03 is prepared to operate with voltages between 90 to 250V AC without any previous operation. The unit’s mains connector socket has a fuse box with a 500mA fuse and a spare fuse. -
Page 7: Audio Connections
3.1. General The AM-03 is equipped, in the back panel, with six stereo audio inputs and a parallel output that allow to direct the audio signal that is being monitored to, for example, metering instruments, patch panel, etc. For this connections, female connector are supplied. -
Page 8: General
4.1. General The AM-03 Self Amplified Audio Monitor has been designed in accordance with the actual needs of the operators and audio technicians that carry out their labour in TV and radio broadcasting controls, mobile production units and retransmissions, VTR rooms, cinema control cabinets, multi video systems, etc. -
Page 9: Input Selection
5. FIGURE 5 4.3.3. Right channel signal presence In the case that the equipment only disposes of a signal proceeding from right channel, the phase meter will illuminate as shown in figure 6. FIGURE 6 AEQ AM‐03 Self‐powered Stereo Audio Monitor ... -
Page 10: Stereo Signal In Phase
The headphones connector (1) gives the opportunity to carry out a direct monitoring. The disconnection of the speakers will be done automatically when the headphones jack is inserted on the connector. All the controls (gain, balance, etc.) will remain operative in this listening mode. AEQ AM‐03 Self‐powered Stereo Audio Monitor ... -
Page 11: Front Panel
DESCRIPTION OF AM-03 FRONT AND BACK PANELS 5.1. AM-03 front panel 1.- Headphones connector. 2.- Left channel mid - high frequency stereo way. 3.- Phase meter. 4.- Monoaural low frequency way. 5.- Right channel mid - high frequency stereo way. -
Page 12: Technical Specifications
TECHNICAL SPECIFICATIONS 6.1. Technical specifications of AM-03 Inputs: 6 stereo inputs, selectable from the front panel, electronically balanced with RF filter. Impedance: > 100 KOhm. Nominal level: 0 dBv. Connectors: Male connector, 3 pole - pitch 5.08mm. Outputs: 1 stereo parallel audio output to the selected input, with male connector, 3 pole - pitch 5.08mm... -
Page 13: Additional Information
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. AEQ AM‐03 Self‐powered Stereo Audio Monitor ...