Enhanced Charging Service Configuration
Configuring Rule Definitions
This section describes how to create and configure rule definitions.
To create and configure a ruledef use the following configuration:
configure
active-charging service
ruledef
rule-application { charging | post-processing | routing }
end
Notes:
If the same ruledef is to be used for charging in one rulebase and for post-processing in another, then two
separate identical ruledefs should be defined.
For information on all the protocol types, expressions, operators, and conditions supported, refer to the ACS
Ruledef Configuration Mode Commands chapter of the Command Line Interface Reference.
The
rule-application
a ruledef as a charging ruledef.
In 14.1 and earlier releases, a maximum of 10 rule expressions (rule-lines) can be added in one ruledef.
In 15.0 and later releases, a maximum of 32 rule expressions (rule-lines) can be added in one ruledef.
Verifying your Configuration
To verify your configuration, in the Exec Mode, enter the following command:
show active-charging ruledef { all | charging | name ruledef_name | post-processing |
routing }
Configuring Group of Ruledefs
A group-of-ruledefs enables grouping rules into categories, so that charging systems can base the charging policy on the
category.
To create and configure a group-of-ruledefs, use the following configuration:
configure
active-charging service
group-of-ruledefs
add-ruledef priority
ruledef
command specifies the ruledef type. By default, if not specified, the system considers
Cisco ASR 5x00 Enhanced Charging Services Administration Guide ▄
Configuring the Enhanced Charging Service ▀
87