1. Manuals
  2. Brands
  3. SolarEdge Manuals
  4. Battery Charger
  5. Installation and configuration

SolarEdge EV Charger Installation And Configuration

Cable
Hide thumbs
1
2
3
4
5

Quick Links

EV Charger Cable Installation and EV Charger Configuration

Contents
Version History
Version 1.1, Apr 2018 - Clearance updated; addition of operating instructions
l
Version 1.0 , Feb 2018 - Initial release
l

Introduction

The EV Charger Cable is used with SolarEdge's EV Charging Single Phase Inverter (referred to as inverter). This document describes how to install and connect
the cable and how to configure the EV Charger.

Package Contents

A holder that is mounted on a wall/ pole (screws are not included)
l
EV Charger Cable
l
Cable lock
l

Required Equipment

4 screws
l
Screwdriver
l
Drill
l
NOTE
Connection to the SolarEdge monitoring platform is required for first EV charging.
Mounting the EV Charger Cable
Install the EV Charger Cable after the inverter is already installed (refer to the Inverter Installation Guide).
1. Connect the EV charger Cable to the inverter (see Figure 1):
a. Align the two white arrows on the EV charger cable connector with the white dot on the inverter connector located at the bottom of the inverter: the
dot should be between two arrows.
b. Plug the connector into the EV connector.
c. Rotate the cable connector clockwise to fasten it.
Figure 1: EV cable connection
1
1
1
1
1
3
4
5
5
1
loading

Related Manuals for SolarEdge EV Charger

Summary of Contents for SolarEdge EV Charger

  • Page 1: Table Of Contents

    1. Connect the EV charger Cable to the inverter (see Figure 1): a. Align the two white arrows on the EV charger cable connector with the white dot on the inverter connector located at the bottom of the inverter: the dot should be between two arrows.
  • Page 2 4. Drill the holes. 5. Position the EV Charger Cable (with the plug at the top) in the groove of the holder and attach the holder to the wall using the screws (See Figure 2). This allows cable strain relief.

  • Page 3: Ev Charger Activation And Configuration

    EV Charger Activation and Configuration After installing the EV Charging Single Phase Inverter, and the EV Charger Cable, the EV Charger should be activated in order to enable charging. This chapter describes how to activate and configure the EV Charger using the SolarEdge monitoring platform mobile application.

  • Page 4: Ev Charger Configuration And Monitoring

    EV Charger Cable Installation and EV Charger Configuration 5. When the EV Charger is activated and ready for configuration, the following screen is displayed. Tap OK. Figure 6: EV Charger activated EV Charger Configuration and Monitoring 1. Before starting, make sure that:...

  • Page 5: Specifications

    2. Hold the EV Charger plug and unwind the cable from the holder. 3. Connect the EV Charger plug tothe charging socket of the vehicle and push firmly until it clicks into the socket. The inverter will sound 1 short beep and the blue LED will turn on (the green LED turns off) to indicate a proper connection.