Table of Contents
Presetting the radio stations
You can preset 50 stations for FM and AM. Before
tuning, make sure that you have turned down the
volume to the minimum.
Press TUNER (or TUNER/BAND on the remote
1 1
control) to select the frequency (AM or FM) you
want.
Every time you press this button, AM and FM
changes alternately.
Press TUNING DOWN/UP on the front panel
2 2
until the frequency indication starts to change.
otes
Automatic Tuning
•
Press TUNING DOWN/UP for more than 0.5 seconds.
- Scanning stops when the unit tunes in a station.
Manual Tuning
•
Press TUNING DOWN/UP briefly and repeatedly.
Press PROG./MEMO..
3 3
A preset number will flash in the display window.
Press PRESET DOWN/UP (or PRESET (
4 4
on the remote control) to select the preset
number you want.
Listening to the radio
Press TUNER (or TUNER/BAND on the remote
1 1
control) to select the frequency
(AM or FM) you want.
Every time you press this button, AM and FM
changes alternately.
The last received station is tuned in.
Press PRESET DOWN/UP (or PRESET (
2 2
on the remote control) repeatedly to select the
preset station you want.
- Each time you press the button, the unit tunes in
one preset station at a time.
Adjust the volume by rotating VOLUME
3 3
CONTROL KNOB (or pressing VOLUME
(
) on the remote control) repeatedly.
/
To listen to non-preset radio stations
• Use manual or automatic tuning in step 2.
• For automatic tuning, press and hold TUNING
DOWN/UP on the front panel.
Press PROG./MEMO..
5 5
- The station is stored.
Repeat steps 2 to 5 to store other stations.
6 6
To clear all the memorized stations
Press and hold PROG./MEMO. on the front panel
for about two seconds, "CLEAR" appears on the display
window and then press CLEAR, the stations are cleared.
For your reference
If all stations have already been entered, FULL message
will appear in the display window for a moment and then
a preset number will blink. To change the preset number,
follow the steps 4-5.
To recall presets
Press and hold PRESET DOWN/UP (or PRESET
(
) on the remote control) until the desired preset
/
number appears or press it repeatedly.
)
/
To turn off the radio
Press POWER (
select another function mode (CD, TAPE or AUX).
For your reference
If an FM program is noisy
•
Press MODE/RIF so that "STEREO" disappears on
)
/
the display window. There will be no stereo effect,
but the reception will be improved. Press MODE/RIF
again to restore the stereo effect.
To improve reception
•
Repose the supplied antennas.
otes
• Use MODE/RIF (Radio Interference Filter) function to
switch to mono reception if stereo reception is distorted
by noise.
• When recording the MW(AM) broadcast, beat noises
may occur. If it does, press MODE/RIF once.
STANDBY/ON) to turn the unit off or
11
Hide quick links:
Table of Contents
