Bluetooth Connection Procedure (Gm, /C8 Option) - YOKOGAWA GX10 User Manual
Gx series; gp series; gm series; smartdac+ communication command
Hide thumbs
Also See for GX10:
- User manual (590 pages) ,
- User manual (707 pages) ,
- User manual (82 pages)
Table of Contents
1.2 Operations over the Serial Interface (RS-232, RS-422/485, USB, Bluetooth)
1.2.6
Bluetooth Connection Procedure (GM, /C8 option)
1-10
The procedure to connect a GM to the PC via Bluetooth is shown below. For instructions on
how to use the PC, see the user's manual for your PC.
Configuring the GM
Turn the Bluetooth function on (default value is on). For the procedure, see section 2.20,
"Configuring the Bluetooth Communication Function," in the Data Acquisition System GM
User's Manual (IM 04L55B01-01EN).
Connecting the GM to the PC
1
Check whether the BT LED in the GM status display area is on. If the LED is off, hold
down the GM USER1 key for at least 3 seconds.
The BT LED in the GM status display area is turns on, the GM enters the connection standby
state.
2
Perform a pairing operation from the PC.
A 6-digit authentication code appears on the GM's 7 segment LED. Check that this
authentication code matches that shown on the PC, and pair the devices. When
pairing is complete, a COM port will be assigned.
Note
The GM stores up to eight entries of pairing information. This information is retained even when the
power is turned off.
The pairing operation is not necessary in subsequent connections.
3
Perform the operation for connecting from the PC to the GM.
See "Appendix 7 Bluetooth Communication Connection Flow Chart" and section
"2.2.7 How to Use Commands".
BT LED
IM 04L51B01-17EN
Table of Contents
