Table of Contents
SERVICE ADJUSTMENTS
(4) Change to PAL50p mode (PAL signal input, User Menu setting
and repeat procedure (2)-(3) for PAL50p mode.
(5) Change to NTSC60p mode (NTSC signal input, User Menu setting
PROGRESSIVE) and repeat procedure (2)-(3) for NTSC60p mode.
[C52-WD9000 only]
(6) Change to PAL HD (1080i/50) mode, and repeat procedure (2)-(3) for PAL HD mode.
(＊)Setting procedure of PAL HD mode.
(a) Receive 1080i (50Hz).
(b) Set the Scan Mode to HD.
(c) Set the Picture Mode to Favorite.
Film Mode: Off
Dynamic Contrast: Off
Color Manager: Off
(d) Set Picture Size to 16:9 mode.
2.3 RASTER TILT ADJUSTMENT (DEFLECTION YOKE ADJUSTMENT)
Adjustment preparation
(1) Face the set East or West.
(2) Receive the NTSC cross-hatch signal.
(3) Contrast should be set MAX and the other controls should be set CENTER.
(4) The lens focus should be coarsely adjusted.
(5) The electrical focus should be coarsely adjusted
(6) The digital convergence should not be corrected.
(7) Turn the main power switch off.
(8) Press and hold the "SERVICE ONLY" SW. on SIGNAL P.W.B. and switch on the power.
Adjustment procedure
(1) Apply covers to the R and B lenses or short the TS (2P EH Connector) on R and B CPT P.W.B. to project only
green beam.
(2) Then loose Dys' screws (R, G, and B) before start alignment of raster tilt.
DY
PRT GUN
30
FUNCTION \ SCAN MODE \ PROGRESSIVE)
FUNCTION \ SCAN MODE \
SCREW
Chapters
Table of Contents
