AEQ SWING Quick User Manual

SWING Quick User's Guide (EURO ISDN)

1

2

6

1) Turning the Equipment On:

•

Before connecting the power supply to the equipment make sure that the Power On

switch (7) is on the OFF position.

•

Once the power supply's threaded connector is properly connected to the equipment (6),

then the power supply can be connected to the outlet.

•

After all previous steps have been completed it is now save to turn on the equipment

using the Power On switch (7). The LCD screen should be on, indicating that all is

working properly.

2) Connection to the "S" Interface Jack:

•

Make sure that the DIP micro switch 8 is up. Switch 1 selects between the basic ISDN

standards (down = Europe and other countries, up = USA & Canada). If they are not in

the rigth position, place them in the up position and restart the equipment.

•

In most cases the connection to ISDN will be done through the RJ-45 ETSI connector (2).

Use the cable supplied with the equipment to connect it to the "S" interface jack (if the

ISDN jack installed by the ISDN service provider is RJ-11, "U" type, please refer to the

User's Manual for further explanation).

3) Configuring the ISDN Terminal Adapter. In order for the Swing to receive or place any

calls the Terminal Adapter must be configured correctly, this is accomplished by entering

MSN numbers, in the following manner:

•

Press the Set Up button on the keypad to access the Set Up menu.

•

You will see the "1. ISDN" option on the LCD screen, press the Yes button to enter into

this option and set up the MSN numbers.

•

Press the (

Press the Yes button to enter into the desired option.

•

NUMBER LINE 1 and 2 are entered by pressing the corresponding numbers from the

keypad. Press the

correct to save it.

Note: the three digit area code should not be included when entering these numbers.

•

The equipment should be restarted at this point. Any changes and entries will be saved

even when the equipment is turn off.

AEQ SWING Quick User's Guide (EURO ISDN) - Revision 02/07

3

7

) keys to navigate between NUMBER LINE 1 and NUMBER LINE 2.

key to erase any mistakes. Press the Yes button once the number is

4

8

9

5

10