Configuring The Optimal Bypass Tunnel Selection Interval; Enabling Snmp Notifications For Mpls Te - HP MSR2000 Configuration Manual
Msr series mpls
Hide thumbs
Also See for MSR2000:
- Configuration manual (453 pages) ,
- Manual (73 pages) ,
- High availability configuration manual (91 pages)
Table of Contents
Step
1.
Enter system view.
2.
Enter interface view of the
connecting interface between
the PLR and the protected
node.
3.
Configure node fault detection.
Configuring the optimal bypass tunnel selection interval
If you have specified multiple bypass tunnels for a primary CRLSP, MPLS TE selects an optimal bypass
tunnel to protect the primary CRLSP. Sometimes, a bypass tunnel might become better than the current
optimal bypass tunnel because, for example, the reservable bandwidth changes. Therefore, MPLS TE
needs to poll the bypass tunnels periodically to update the optimal bypass tunnel.
Perform this task on the PLR to configure the interval for selecting an optimal bypass tunnel:
Step
1.
Enter system view.
2.
Enter MPLS TE view.
3.
Configure the interval for
selecting an optimal bypass
tunnel.
Enabling SNMP notifications for MPLS TE
This feature enables generating SNMP notifications for MPLS TE upon MPLS TE state changes, as defined
in RFC 3812. The generated SNMP notifications are sent to the SNMP module.
To enable SNMP notifications for MPLS TE:
Step
1.
Enter system view.
2.
Enable SNMP notifications
for MPLS TE.
For more information about SNMP notifications, see Network Management and Monitoring
Configuration Guide.
Command
system-view
interface interface-type
interface-number
•
(Method 1) Enable RSVP hello
extension on the interface:
rsvp hello enable
•
(Method 2) Enable BFD on the
interface:
rsvp bfd enable
Command
system-view
mpls te
fast-reroute timer interval
Command
system-view
snmp-agent trap enable te
86
Remarks
N/A
N/A
By default, RSVP hello
extension is disabled, and
BFD is not configured.
For more information about
the rsvp hello enable
command and the rsvp bfd
enable command, see
"Configuring RSVP."
Remarks
N/A
N/A
By default, the interval is 300
seconds.
Remarks
N/A
By default, SNMP notifications for
MPLS TE are enabled.
- Quick Links:
- Basic Concepts
Hide quick links:
Table of Contents
