Table of Contents
Install the DD6300, DD6800, or DD9300 system into a rack
5. Use an 18-inch screwdriver (minimum) to secure the rear of the rail to the
NEMA channel using one screw.
6. Tighten the front screw.
7. Repeat for the other rail.
CAUTION
Data Domain systems are heavy. Always use two people or a mechanical lift to
move a system.
Figure 12 Warning about lifting the system
CAUTION
The system controller should be installed in the pre-defined location for the
l
system controller in the rack to comply with Data Domain rack mounting
guidelines.
Do not apply AC power to the system controller until all expansion shelves
l
and cables are installed.
Ensure the PSNT label, which is in a slot just beneath the power supply on the
l
rear of the chassis is not damaged or snagged during the installation of the
system into the rack.
Procedure
1. From the front of the rack, lift the chassis to install the system in the rack in the
correct location.
Install the DD6300, DD6800, or DD9300 system into a rack
Install the System in the Rack
43
Hide quick links:
Table of Contents
