Page 3
2. By default, the REMEC Tube is mounted with vertical polarization. If necessary, switch the polarization by releasing four countersink screws, rotating the central adaptor 90 degrees, and re-tightening the screws. Location Pin for H polarization Location Pin for V polarization (DEFUALT) PTP 820 REMEC Adaptor Installation Guide...
Page 4
3. Mount the O-Ring supplied in the PTP 820S/RFU-C REMEC Adaptor kit for single polo on the appropriate place on the Tube. Make sure the mounting direction is correct, as shown in the section view. 4. Locate and match the ADAPTOR to the antenna interface. PTP 820 REMEC Adaptor Installation Guide...
Page 5
5. Lock the four latches PTP 820 REMEC Adaptor Installation Guide...
Page 6
Note: PTP 820S/RFU-C mounting screws and washers can be supplied either assembled on the PTP 820S or RFU-C, or as a part of the PT 820S or RFU-C kit. Make sure the radio polarization mounting direction is correct. PTP 820 REMEC Adaptor Installation Guide...
Page 7
1 Mount the two O-Rings supplied in the Coupler kit and twist on the Coupler body, as defined in the Coupler kit instructions. 2 Mount the coupler on the PTP 820S/RFU-C REMEC Adaptor using the four M8 screws and washers supplied in the Coupler kit, and tighten the screws. PTP 820 REMEC Adaptor Installation Guide...
Page 8
3 Proceed with mounting the RFU-C or PTP 820S radios, as defined in the Coupler kit instructions. PTP 820 REMEC Adaptor Installation Guide...
Page 9
PTP 820C Splitter kit, and tighten the screws. 2. Proceed with mounting the IP-20C Radio, as described in the Splitter kit instructions Important! For the warranty to be honored, install the unit in accordance with the instructions above. PTP 820 REMEC Adaptor Installation Guide...
Screwdriver Phillips #2 Procedure 1. Mount the O-Ring supplied in the PTP 820SS/ RFU-C REMEC ADAPTOR KIT on the REMEC Tube. Make sure the mounting direction is correct, as shown in the section view PTP 820 REMEC Adaptor Installation Guide...
Page 11
2 Proceed with mounting the PTP 820S/RFU-C or PTP820C as defined in the OMT kit instructions. PTP820S/RFU-C Configuration PTP820C Configuration Important! For the warranty to be honored, install the unit in accordance with the instructions above. PTP 820 REMEC Adaptor Installation Guide...