Connecting The Power Cables; Connection Diagram - ABB ACS560 Hardware Manual
Hide thumbs
Also See for ACS560:
- Firmware manual (514 pages) ,
- Quick installation and start-up manual (306 pages) ,
- Hardware manual (240 pages)
Table of Contents
76 Electrical installation
R6...R8
R6...R8
4
3
Connecting the power cables
Connecting the power cables
￭
Connection diagram
Connection diagram
ACS560-01
L1
L2
PE
2b
2a
(PE)
PE
(PE)
L1
L2
1
For alternatives, see section
1
For alternatives, see section
2
Use a separate grounding PE cable (2a) or a cable with a separate PE conductor (2b)
if the conductivity of the shield does not meet the requirements for the PE conductor
2
Use a separate grounding PE cable (2a) or a cable with a separate PE conductor (2b) if the conductivity
(see page 54).
of the shield does not meet the requirements for the PE conductor (see
3
cables (page
360-degree grounding is recommended if shielded cable is used. Ground the other end
50)).
of the input cable shield or PE conductor at the distribution board.
3
360-degree grounding is recommended if shielded cable is used. Ground the other end of the input cable
4
360-degree grounding is required.
shield or PE conductor at the distribution board.
5
External brake resistor.
6
Use a separate grounding cable if the shield does not meet the requirements of
IEC 61439-1 (see page 54) and there is no symmetrically constructed grounding
conductor in the cable (see page 57).
Note:
3
UDC+
L3
R-
R+
3
3
5
1
L3
Selecting the supply disconnecting device
Selecting the supply disconnecting device (page
Electrical installation 67
3
4
3
Electrical installation 77
T1/U T2/V T3/W
4
V1
W1
U1
3 ~ M
on page
49).
Selecting the power
6
53.
- Quick Links:
- Fault Tracing
Hide quick links:
Table of Contents
