Table of Contents
FM Operation
Selecting the FM Mode
The unit will automatically select a FM radio station with a good signal.
Select the TUNER mode by turning the FUNCTION dial on the unit or pressing the TUNER
button on the remote control until the display reads "TUNER".
GB
Searching for a Station Automatically
In TUNER mode, press and hold the
starts searching for a station. The tuner will stop searching after tuning into a radio station.
The search may not stop at a station with a very weak signal.
Searching for a Station Manually
In TUNER mode, repeatedly press the
frequency reception quality is found.
With FM radio it may be necessary to fine tune each station by pressing the
remote control repeatedly. Each press will adjust the frequency by 0.05MHz. If reception is still
poor adjust the position of the aerial or try moving the radio to another location.
Audio Mode
Press the SELECT button repeatedly to switch between STEREO or MONO modes. The
display will show 'FM ST' for stereo mode and 'FM MONO' for mono mode.
The unit will automatically switch between stereo and mono mode, when stereo mode
is selected but you can override this and switch this function manually by changing it to
mono mode. This is helpful when receiving poor signal reception.
For Better Reception
Fully unwind the FM aerial. Extend the FM aerial and place it in the position that offers
the best sound reception.
The unit will automatically switch between stereo and mono mode. This is helpful when
receiving poor signal reception.
Presetting Radio Stations
Your unit can store up to 20 radio stations in its memory. If the unit is disconnected from
the mains supply the preset stations will not be lost.
24
buttons on the remote control until the tuner
buttons on the remote control until the desired
buttons on the
Table of Contents
