Honeywell TB7300A5014B Installation Instructions Manual page 14

TB7300 SERIES COMMUNICATING FAN COIL THERMOSTATS

INSTALLER CONFIGURATION PARAMETER MENU

This section describes the parameters available for TB7300 Series thermostat configuration. The TB7300 Series can

be programmed at the thermostat or through WEBStation-AX, with the following exception: Wireless models must have

the Com Addr, PAN ID, and Channel set at the thermostat before adding to the wireless network or doing any

programming in WEBStation-AX.

To program the thermostat through WEBStation-AX, refer to the BACnet Integration Reference Guide for BACnet

models (Form No. 63-4524) or the Wireless Installation and Integration Reference Guide for TB7200, TB7300, TB7600

Thermostats (Form No. 63-4522) for wireless models.

Local configuration:

1. To enter configuration, press and hold the middle button (°C/°F or Override) for 8 seconds

2. If a password lockout is active, "Password" is prompted. Enter password value using the "up" and "down" arrows

and press the middle button again to gain access to all configuration properties of the thermostat. A wrong pass-

word entered will prevent local access to the configuration menu.

3. Press the same middle button repetitively to scroll between all the available parameters

4. Use the up and down key to change the parameter to the desired value.

5. To acknowledge and save the new value, press the middle button again.

6. The next listed parameter is now displayed.

Fan

Re-starts the configuration parameter list at the beginning.

°C/°F

Enters the configuration mode. Press and hold for 8 seconds.

Override

Pressing repetitively will scroll all available parameters one by one.

Down

Adjust parameter value down.

Up

Adjust parameter value up.

Configuration

parameters

PswrdSet

Configuration parameters menu

access password

Default value = 0

Range is: 0 to 1000

Thermostat networking address

Com Addr

Default value = 254

Range is: 0 to 254

Personal Area Network

PAN ID

Identification

Default value = 0

Range is: 0 to 500

62-2018—05

Table 10. Configuration interface

Table 11. Configuration parameters

Default value

Significance and adjustments

This parameter sets a protective access password to prevent

unauthorized access to the configuration menu parameters. A default

value of "0" will not prompt a password or lock the access to the

configuration menu.

Range is: 0 to 1000

If the thermostat is installed as a stand-alone unit, this parameter

will not be used or displayed

For BACnet models valid range to use is from 0 to 127. Default value

of 254 disables BACnet communication for the thermostat.

For wireless models valid range is 0 to 254 with a maximum of 30

thermostats per WEB-2xx controller and 50 thermostats per WEB-

6xx/-7xx controller.

Conditional parameter to wireless models (TB73xxX5x14W)

This parameter will only appear on wireless thermostats. If the

thermostat is BACnet, this parameter will not be used or displayed

This parameter (Personal Area Network Identification) is used to link

specific thermostats to a single specific WEBs controller with a

wireless communication card (TB-VWG-APP-1014). For every

thermostat reporting to a WEBs controller and wireless

communication card (maximum of 30 thermostats per WEB-2xx

controller and 50 thermostats per WEB-6xx/-7xx controller) be sure

you set the SAME PAN ID value both at the wireless communication

card and the thermostat(s).

The default value of 0 is NOT a valid PAN ID. The valid range of

available PAN ID is from 1 to 500

14