Cisco ASR 9000 Series Software Manual page 90
Layer 3 multicast routing
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Configuring MSDP MD5 Password Authentication
Command or Action
Step 5
ttl-threshold ttl-value
Example:
RP/0/RSP0/CPU0:router(config-msdp)#
ttl-threshold 8
Step 6
exit
Example:
RP/0/RSP0/CPU0:router(config-msdp)#
exit
Step 7
ipv4 access-list name [sequence-number]
permit source [source-wildcard]
Example:
RP/0/RSP0/CPU0:router(config)# ipv4
access-list 100 20 permit 239.1.1.1
0.0.0.0
Step 8
commit
Configuring MSDP MD5 Password Authentication
SUMMARY STEPS
1. configure
2. router msdp
3. peer peer-address
4. password {clear | encrypted} password
5. commit
6. show mfib [vrf vrf-name] [ipv4 | ipv6] hardware route {* | source-address | group-address[/prefix-length]}
location node-id
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 5.1.x
90
Implementing Layer-3 Multicast Routing on Cisco IOS XR Software
Purpose
(Optional) Limits which multicast data is sent in SA messages to an
MSDP peer.
• Only multicast packets with an IP header TTL greater than or equal
to the ttl-value argument are sent to the MSDP peer specified by
the IP address or name.
• Use this command if you want to use TTL to examine your
multicast data traffic. For example, you could limit internal traffic
to a TTL of 8. If you want other groups to go to external locations,
send those packets with a TTL greater than 8.
• This example configures a TTL threshold of eight hops.
Exits the current configuration mode.
Defines an IPv4 access list to be used by SA filtering.
• In this example, the access list 100 permits multicast group
239.1.1.1.
• The ipv4 access-list command is required if the keyword list is
configured for SA filtering in
Step 3, on page
89.
