Cautions When Data Overwrite Kit (Gp-1060) Is Installed - Toshiba e-STUDIO520 Service Handbook
Multifunctional digital systems
Hide thumbs
Also See for e-STUDIO520:
- Service manual (466 pages) ,
- User functions manual (202 pages) ,
- Network administration manual (124 pages)
Table of Contents
(12) Perform 1*-102 (Clearing the image data).
Note:
Note:
Following image data are deleted when 1*-102 is performed.
-
Images of fax polling transmission
-
Images of fax Mailbox and box information
-
Images of fax transmission
-
Images of fax reception
(13) Turn the power OFF.
(14) Turn the power ON.
(15) Set the dial type. [USER FUNCTIONS] → [ADMIN] → [FAX] → [INITIAL SETUP]
5.3.3
Cautions when Data overwrite kit (GP-1060) is installed
When the Data overwrite kit (GP-1060) is installed, follow the cautions below.
<>
Before disposing of the HDD of the equipment, be sure to perform 08-1426 (forcible HDD data clearing)
and confirm that deleting of the HDD data is completed.
•
Check that the percentage is 100% and "HDD Erase [OK]" appears on the upper left of the screen.
•
Check that the version (SYS V1.0) is displayed on the lower right of the screen.
* When the scrambler board is installed, data in the HDD are overwritten with encrypted data and
erased.
<>
Before the SYS board is disposed, the following codes can be performed.
•
08-1427 (Forcible NVRAM data all clearing)
•
08-1428 (Forcible SRAM backup data all clearing)
Caution
If these codes are performed, the equipment cannot be started up.
© 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO520/523/600/603/720/723/850/853
5 - 157
05/11
TROUBLESHOOTING
5
Hide quick links:
Table of Contents
Troubleshooting
