Table of Contents
Director Speed
At the Director Speed field, choose 1 Gb/sec or 2 Gb/sec to select the speed of
Fibre Channel operation.
Note:
cause the following warning/confirmation message to display: "All FPM ports
will be held inactive while the switch is configured to 2
Gb/sec speed. Do you want to continue?"
Configuring Fabric Parameters
Use procedures in this section to set parameters on the director for fabric
operation through the Configure Fabric Parameters dialog box. These parameters
are stored in NV-RAM on the director.
1. Verify that the director is set offline. For instructions, see
2. Choose Configure > Operating Parameters > Fabric Parameters. The
Figure 46: Configure Fabric Parameters dialog box
3. Use information under
4. After you change settings, click the Activate button.
Director 2/64 Installation Guide
Changing the switch speed to 2 Gb/s with any 1 Gb/s FPM cards installed will
Offline" on page 85.
Caution:
Setting the director offline terminates all Fibre Channel connections.
Configure Fabric Parameters dialog box displays, as shown in
parameters in this dialog box.
"Fabric
Parameters" to change settings as required for
Installing and Configuring the Director
"Setting the Director
Figure
46.
91
Table of Contents
