Debug Interface - Cisco Catalyst 3650 series Command Reference Manual
Cisco ios xe everest 16.5.1a
Hide thumbs
Also See for Catalyst 3650 series:
- Hardware installation manual (126 pages) ,
- Configuration manual (94 pages) ,
- Manual (94 pages)
Table of Contents
debug interface
To enable debugging of interface-related activities, use the debug interface command in privileged EXEC
mode. To disable debugging, use the no form of this command.
debug interface {interface-id| counters {exceptions| protocol memory}| states}
no debug interface {interface-id| counters {exceptions| protocol memory}| states}
Syntax Description
interface-id
counters
exceptions
protocol memory
states
Command Default
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Release
Cisco IOS XE 3.3SE
Usage Guidelines
If you do not specify a keyword, all debug messages appear.
The undebug interface command is the same as the no debug interface command.
When you enable debugging on a switch stack, it is enabled only on the active switch. To enable debugging
on a stack member, you can start a session from the active switch by using the session switch-number EXEC
command. Then enter the debug command at the command-line prompt of the stack member.
ID of the physical interface. Displays debug messages for the specified physical
port, identified by type switch number/module number/port, for example,
gigabitethernet 1/0/2.
Displays counters debugging information.
Displays debug messages when a recoverable exceptional condition occurs
during the computation of the interface packet and data rate statistics.
Displays debug messages for memory operations of protocol counters.
Displays intermediary debug messages when an interface's state transitions.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
debug interface
Modification
This command was introduced.
31
Table of Contents
