Related Laws And Regulations; Precautions In Sales Promotion - Hitachi NV 50AG2 Technical Data And Service Manual

As nailers and staplers are designed to instantaneously drive nails and staples, there is an ever-present danger of

misfiring and subsequent possible serious injury. Accordingly, close attention in handling is absolutely necessary

at all times. Carefully ensure that the customer is fully aware of the precautions listed in the Handling Instructions

provided with each unit.

While there are no specific safety regulations, there are related items various general safety regulations with

which the salespersons should be familiar in order to advise the customer properly. Please check your national

and/or local regulations for applicable items.

Some applicable items are outlined below.

(1) Europe

EUROPEAN STANDARD

(2) The U.S.A.

OSHA

ANSI SNT-101-2002

The salespersons must instruct customers to observe the following precautions.

(1) An air pressure less than 4.4 bar (4.5 kgf/cm

performance, service life and safety of the Model NV 50AG2. Pay special attention to the pressure level,

capacity and piping of the air compressor. [If using an air compressor capable of high air pressure [9.8 bar

(10 kgf/cm

2

, 140 psi) or more], be sure to install a pressure reducing valve on the air compressor and limit the

pressure to 7.8 bar (8 kgf/cm

(2) To protect the Model NV 50AG2 against rust, apply oil and perform idle driving two or three times to spread the

applied oil fully inside this nailer when it is not used for a long time. Also coat the steel parts with oil.

(3) Rust inside this nailer can cause performance degradation or failure. The salespersons must instruct the

customers to drain the air compressor tank without fail.

(4) The salespersons must instruct the customers, especially those who use the Model NV 50AG2 frequently, to

check and maintain this nailer without fail.

(5) The salespersons must instruct the customers to clean and apply the provided oil to the sliding sections of the

pushing lever regularly.

EN792-13 JUNE 2000

HAND-HELD NON-ELECTRIC POWER TOOLS---SAFETY REQUIREMENTS

Part 13: Fastener driving tools

1926.102 Eye and Face Protection

1926.302 Power-Operated Hand Tools

Portable, Compressed-Air-Actuated,

Fastener Driving Tools---Safety Requirements for

2

, 63 psi) or more than 7.8 bar (8 kgf/cm

2

, 112 psi) or less].

--- 10 ---

2

, 112 psi) can affect the