Reset Dot1X Statistics - HP HSR6600 Command Reference Manual
Hide thumbs
Also See for HSR6600:
- Configuration manual (614 pages) ,
- Troubleshooting manual (41 pages) ,
- Security configuration manual (559 pages)
Table of Contents
Default
The unicast trigger function is disabled.
Views
Ethernet interface view
Default command level
2: System level
Usage guidelines
The unicast trigger function enables the network access device to initiate 802.1X authentication when it
receives a data frame from an unknown source MAC address. The device sends a unicast Identity
EAP/Request packet to the unknown source MAC address, and retransmits the packet if it has received
no response within a period of time (set with the dot1x timer tx-period command). This process continues
until the maximum number of request attempts (set with the dot1x retry command) is reached.
Examples
# Enable the unicast trigger function for interface GigabitEthernet 3/0/1.
[Sysname] interface gigabitethernet 3/0/1
[Sysname-GigabitEthernet3/0/1] dot1x unicast-trigger
Related commands
display dot1x
•
dot1x timer tx-period
•
dot1x retry
•
reset dot1x statistics
Use reset dot1x statistics to clear 802.1X statistics.
Syntax
reset dot1x statistics [ interface interface-list ]
Views
User view
Default command level
2: System level
Parameters
interface interface-list: Specifies an Ethernet port list, which can contain multiple Ethernet ports. The
interface-list argument is in the format of interface-list = { interface-type interface-number [ to
interface-type interface-number ] } & <1- 1 0>, where interface-type represents the port type,
interface-number represents the port number, and & <1- 1 0> means that you can provide up to 10 ports
or port ranges. The start port number must be smaller than the end number and the two ports must be of
the same type.
Usage guidelines
If a list of ports is specified, the command clears 802.1X statistics for all the specified ports. If no ports are
specified, the command clears all 802.1X statistics.
143
Table of Contents
