Configuring The Display; Setting The Interface Language; Setting The Contrast; Configuring Operator - ABB LLT100 Operating Instructions Manual
Laser level transmitter oi-llt100-en rev. d
Hide thumbs
Also See for LLT100:
- Operating instruction (4 pages) ,
- Functional safety manual (32 pages)
Table of Contents
9 Configuring the display
You set all LCD-specific parameters from the Display
configuration menu.
9.1 Setting the interface language
To set language in which the interface is displayed:
1. From the Display menu, select Language.
2. From the Language menu, select the language in which
you want to display the interface.
English is selected by default, but you can also select
German [Deutsch] or French [Français]).
3. Press OK.
9.2 Setting the contrast
To set the display contrast:
1. From the Display menu, select Contrast.
2. From the Contrast screen, press the Up or Down arrow to
increase or decrease the contrast percentage.
By default, the contrast is set to 100%.
3. Press OK.
9.3 Configuring Operator pages
The LLT100 screen can display any of four different Operator
pages. Operator pages are intended to display relevant
information about ongoing process measurements. They can
display graphs and/or up to three lines of data.
Operator page 1 appears by default once the LLT100 is
powered on.
To configure an operator page:
1. From the Display menu, select Operator Pages > Operator
Page n ( n being the number of the operator page that you
want to configure).
2. From the Operator Page n screen, select Display Mode >
Edit.
3. From the edit page, select the display mode and press OK.
There are eight modes available, expressed as N x M where
N represents the number of rows, and M, the number of
characters. Here are examples of display modes:
Operator
page number
4. Once the display mode is selected, press Back to go and
select the value displayed on each line/graph of the selected
display mode.
The values available for display depend on the display
mode. For example, if you select the 2×9 display mode, the
3rd line will not be available for configuration.
5. From the selected Line or Bargraph menu, press Edit and
select the data that you want to display.
6. Press OK.
7. (if necessary) Repeat steps 4 to 6 to configure all remaining
values.
Below is an example of Operator page 2 in a 2×9 configuration
displaying ullage and amplitude:
9.4 Configuring Autoscroll
The autoscroll feature allows you to move automatically
between Operator pages, and at a set time interval. This is
useful when you simply want to record specific values manually
without touching the instrument. This feature is disabled by
default.
1 × 6 (A)
2 × 9 + Graph
3 × 9
OI-LLT100-EN Rev. D | User Guide 27
- Quick Links:
- Electrical
- Connecting the Instrument
Hide quick links:
Table of Contents
