Replacing The Hot-Plug Power Supply Unit - Fujitsu PRIMERGY TX300 S4 Operating Manual
Hide thumbs
Also See for PRIMERGY TX300 S4:
- User manual (276 pages) ,
- Options manual (137 pages) ,
- System configuration and order-information manual (17 pages)
Table of Contents
Hot-plug power supply units
8.1.1
Replacing the hot-plug power supply unit
Figure 28: Unlocking and removing the power supply unit
V
CAUTION!
Before replacing a non defective power supply unit in a non-redundant
configuration (only one power supply unit present) the server must be
switched OFF.
Ê Remove the cable from the installed power supply unit.
Ê Push the green catch in the direction of the arrow (1) while pulling the power
supply unit out of its mounting location (2) by the handle.
Ê Slide the new power supply unit into the empty slot until it clicks into place.
I
Make sure that the power supply unit engages correctly in the slot and
is locked in position.
This is the only way to avoid the power supply unit being shaken out
of its mountings and damaged during transportation.
Ê Connect the newly installed power supply unit.
96
Operating manual
Hot-plug components
TX300 S4
Table of Contents
