Monitoring And Maintaining Tunneling Status - Cisco Catalyst 3750-E Software Configuration Manual
Hide thumbs
Also See for Catalyst 3750-E:
- Getting started manual (27 pages) ,
- Product support bulletin (6 pages) ,
- Configuration handbook (359 pages)
Table of Contents
Monitoring and Maintaining Tunneling Status
Monitoring and Maintaining Tunneling Status
Table 17-2
Layer 2 protocol tunneling.
Table 17-2
Commands for Monitoring and Maintaining Tunneling
Command
clear l2protocol-tunnel counters
show dot1q-tunnel
show dot1q-tunnel interface interface-id
show l2protocol-tunnel
show errdisable recovery
show l2protocol-tunnel interface interface-id
show l2protocol-tunnel summary
show vlan dot1q tag native
For detailed information about these displays, see the command reference for this release.
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
17-18
shows the privileged EXEC commands for monitoring and maintaining IEEE 802.1Q and
Purpose
Clear the protocol counters on Layer 2 protocol tunneling ports.
Display IEEE 802.1Q tunnel ports on the switch.
Verify if a specific interface is a tunnel port.
Display information about Layer 2 protocol tunneling ports.
Verify if the recovery timer from a Layer 2 protocol-tunnel error disable
state is enabled.
Display information about a specific Layer 2 protocol tunneling port.
Display only Layer 2 protocol summary information.
Display the status of native VLAN tagging on the switch.
Chapter 17
Configuring IEEE 802.1Q and Layer 2 Protocol Tunneling
OL-9775-08
Hide quick links:
Table of Contents
Troubleshooting
