Display Assembly - HP OMEN Maintenance And Service Manual
Model numbers 15-ce000
through 15-ce099
Hide thumbs
Also See for OMEN:
- Maintenance and service manual (102 pages) ,
- User manual (38 pages) ,
- Setup instructions (15 pages)
Table of Contents
Display assembly
IMPORTANT:
and replacement
Before removing the display assembly, follow these steps:
1.
Shut down the computer.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4.
Remove the battery (see
a.
Hinge covers (see
b.
System support brackets (see
c.
Fans (see
d.
Heat sink (see
e.
System board (see
Remove the display assembly:
1.
Disconnect the display panel cable from the system board (1).
2.
Disconnect the WLAN antenna cable from the system board (2).
3.
Release the WLAN antenna cable from the clips securing it to the computer (3).
4.
Open the computer with the bottom facing up (1).
5.
Remove the four Phillips PM2.5×5.7 screws (2) securing the display assembly to the computer.
Make special note of each screw and screw lock size and location during removal
Battery on page
Hinge covers on page
Fans on page
52).
Heat sink on page
System board on page
33), and then remove the following components:
48).
System support brackets on page
56).
61).
49).
Component replacement procedures
65
- Quick Links:
- Product Description
- Battery
- Hard Drive
Hide quick links:
Table of Contents
