Table of Contents
Chapter 2
Hardware Specifications
Dual-Port 10GBASE (MMSR or SMLR) Fiber Configurable Bypass NetMod
The dual-port 10GBASE (MMSR or SMLR) fiber configurable bypass NetMod contains two fiber ports
and link, activity, and bypass LEDs.
Use the following table to understand link and activity LEDs of the fiber interfaces.
Table 2-16
Status
Top
Bottom
Use the following tables to understand the bypass LEDs on the fiber interfaces.
Table 2-17
Status
Off
Steady green
Steady amber
Blinking amber
Use the following table to understand the optical parameters of the fiber interfaces.
Table 2-18
10GBASE MMSR and SMLR NetMod Optical Parameters
Parameter
Optical connectors
Bit rate
Baud rate/encoding/tolerance
Fiber Link/Activity LEDs
Description
For an inline or passive interface:
•
A blinking light indicates the interface has activity.
•
No light indicates there is no activity.
For an inline interface:
A light indicates the interface has activity.
•
No light indicates there is no activity.
•
For a passive interface, the light is always on.
Fiber Bypass LEDs
Description
The interface does not have link and is not in bypass mode.
The interface has link and is passing traffic.
The interface has been intentionally brought down.
The interface is in bypass mode; that is, it has failed open.
10GBASE MMSR
LC duplex
10.000Gbps
10.3125Gbps
64/66b encoding
+/- 100 ppm
Firepower 8000 Series Devices
10GBASE SMLR
LC duplex
10.000Gbps
10.3125Gbps
64/166b encoding
+/- 100 ppm
Firepower 8000 Series Hardware Installation Guide
2-15
Table of Contents
