Activating An Rrpp Domain; Configuring Rrpp Timers - HP A5830 series Configuration Manual
High availability
Hide thumbs
Also See for A5830 series:
- Configuration manual (280 pages) ,
- Command reference manual (249 pages) ,
- Configuration manual (152 pages)
Table of Contents
To specify an assistant-edge node:
To do...
•
Enter system view
•
Enter RRPP domain view
•
Specify the current device as a
transit node of the primary
ring, and specify the primary
port and the secondary port
•
Specify the current device as
the assistant-edge node of the
subring, and specify an edge
port
Activating an RRPP domain
To activate an RRPP domain on the current device, enable the RRPP protocol and RRPP rings for the RRPP
domain on the current device.
Perform this operation on all nodes in the RRPP domain.
To activate an RRPP domain:
To do...
•
Enter system view
•
Enable RRPP
•
Enter RRPP domain view
•
Enable the specified RRPP ring
To prevent Hello packets of subrings from being looped on the primary ring, enable the primary ring on
its master node before enabling the subrings on their separate master nodes. On an edge node or
assistant-edge node, enable/disable the primary ring and subrings separately:
Enable the primary ring of an RRPP domain before enabling the subrings of the RRPP domain.
•
Disable the primary ring of an RRPP domain after disabling all subrings of the RRPP domain.
•
Configuring RRPP timers
Perform this configuration on the master node of an RRPP domain.
To configure RRPP timers:
To do...
•
Enter system view
•
Enter RRPP domain view
Use the command...
system-view
rrpp domain domain-id
ring ring-id node-mode transit [
primary-port interface-type
interface-number ] [ secondary-
port interface-type interface-
number ] level level-value
ring ring-id node-mode assistant-
edge [ edge-port interface-type
interface-number ]
Use the command...
system-view
rrpp enable
rrpp domain domain-id
ring ring-id enable
Use the command...
system-view
rrpp domain domain-id
67
Remarks
—
—
Required
Required
Remarks
—
Required
Disabled by default
—
Required
Disabled by default
Remarks
—
—
Table of Contents
Troubleshooting
